Repaint dash panels and bolster bases. Dropped my 675 Keith Eickerts off at Richie Zuls for a frshen and bump up. New header and tail pipes and a few odds and ends....

That's how to get it done! Nice

Kurt

Winter projects

- new fuel tanks both side
- new outside doors to cabin
- door to the toilet room
- cabin seats both pontoon side
- dash pantings

Half cabin interior, new graphics and get a new Hering prop.

I would (along with a host of some AO and Awesome owners) interested in your cabin door project. Go over to either the AO or Awesome thread and let us know what you find or build.

Mitch Tolan did my panels.

Cool panels sure.
And ok, i can put the thread of that small cabin project to AO.

What do you have like three hours on that new boat and your already upgrading the superchargers!

I switched from stock cast iron manifolds to Revolution Marine alum manifolds in my twin sbc set up and and saved 240lbs in total.....each complete stock iron manifold and riser weighed 85lbs !, each complete Rev Marine mani/riser weighed 25 lbs.

back of the boat went up about an inch

i was at my buddys shop and saw your boat coming a long good its going to be a bad ass set up. i snapped a couple pic if you would like me to post them?