Go Back  Offshoreonly.com > General Discussion > General Boating Discussion
Fountain vs Outer L racing >

Fountain vs Outer L racing

Notices
General Boating Discussion

Fountain vs Outer L racing

Thread Tools
 
Old 10-08-2017 | 02:48 PM
  #51  
Bostonirish's Avatar
Registered
15 Year Member
 
Joined: Sep 2006
Posts: 864
Likes: 63
From: S. Boston MA
Default

One observation I had when I was walking around the dry pits a couple years ago was that I couldn't believe how small and cut down those fountains seemed, and extremely narrow in the stern . The outer limits race boat looked huge compared to them
Bostonirish is offline  
Reply
Old 10-08-2017 | 03:11 PM
  #52  
Registered
10 Year Member
 
Joined: Aug 2014
Posts: 250
Likes: 37
From: MN
Default

Originally Posted by TYPHOON
I agree with all your statements. But my real question was top Kilo speed with the race boats in the Super boat class with there specs. I'm trying to compare the existing race boats. Thanks for keeping this conversation educational all !!!!
I'd say there is a lot of variables to this question.
What kind of water flat, chop, waves, head on or side to side waves. All those things should make a big difference. Unless the water is flat like they usually use for the kilo runs they can t just push the throttles forward and let it go.
I wouldnt think any of these race boats ever set up for nice flat water so that would probably be different setup than any of the teams have really ever set up the boat for. Even if the course is flat the boats still end up with wakes and chop from the other boats on the race course.

If I had to guess they all could get really close # to each other on a top speed kilo run as long as conditions were the same for everyone.
hustlerguy is offline  
Reply
Old 10-08-2017 | 06:41 PM
  #53  
TYPHOON's Avatar
Thread Starter
Registered
25 Year Member
 
Joined: Feb 2001
Posts: 5,136
Likes: 231
From: Edison NJ USA
Default

Originally Posted by ARCTIC1
There is 8 boats in that super v extreme class that were ever built that I know of that are still around & competitive

hooters amh construction
Cooper std
rio roses
freedom
outer-limits has 2 boats
honey party/geico caveman
lucas oil skater

until you have a full showing of boat in this class you can't put a comparison on table to who what where & when is the best & the fastest
that's why superboat class with sthl,jimmy,whm & ect is so much fun to watch,
is the only reason jimmy fast because of JT??? I'm sure that's part of it but other teams have the potential to be rite there with them in a blink
Great question. I'm not sure why Nigel doesn't race with the other Big vee boats with spec power.
TYPHOON is offline  
Reply
Old 10-09-2017 | 09:44 AM
  #54  
Xtremeracing's Avatar
Registered
 
Joined: Mar 2002
Posts: 4,339
Likes: 1
From: Florida
Default

Randy, to answer ur question in a spec class with the same motors Fountain hands done pound for pound is the faster boat.
The concept of other boat racing in the class is doubtful, the reason being the Fountains are just to fast. They have proved it yr after yr. You can go back to the old F2 days they dominated so bad that all the other manufacturers that had tried to compete just gave up. Fountain has single-handedly put an end too numerous offshore race classes whether it was F1 F2 or Super V.
Xtremeracing is offline  
Reply
Old 10-09-2017 | 04:21 PM
  #55  
Registered
10 Year Member
 
Joined: Oct 2014
Posts: 331
Likes: 84
Default

Originally Posted by F1-00 Racing
The direct answer to Typhoons question is the pad design.
SPOT ON. Apples to apples, a true pad-bottom boat will always run faster than a conventional V (with or without steps), but you give up ride comfort as the pad makes for a stiffer ride.
jusabum is offline  
Reply
Old 10-09-2017 | 06:02 PM
  #56  
Platinum Member
20 Year Member
Platinum Member
 
Joined: Apr 2005
Posts: 1,345
Likes: 211
From: St.Peters,Mo/5mm LOTO/LEOPA
Default Twisted metal in p class?

anyone know why twisted metal changed classes ?
flat rate is offline  
Reply
Old 10-10-2017 | 07:00 AM
  #57  
dykstra's Avatar
Platinum Member
20 Year Member
Platinum Member
 
Joined: Dec 2003
Posts: 6,108
Likes: 305
From: Washington, IL
Default

Originally Posted by flat rate
anyone know why twisted metal changed classes ?
Good question.
dykstra is offline  
Reply
Old 10-10-2017 | 07:34 AM
  #58  
Registered
 
Joined: Jul 2010
Posts: 14
Likes: 0
From: Pleasant Hill, Iowa
Default

from the outside looking in I would contribute a lot of instigators success to Kenny Adams he is one of the best crew members in the business top notch guy
ba17a is offline  
Reply
Old 10-10-2017 | 08:32 AM
  #59  
Xtremeracing's Avatar
Registered
 
Joined: Mar 2002
Posts: 4,339
Likes: 1
From: Florida
Default

Originally Posted by ba17a
from the outside looking in I would contribute a lot of instigators success to Kenny Adams he is one of the best crew members in the business top notch guy
I agree Kenny put alot on time and testing in the the boat. When the boat shows up u can rest sure it 110%
Xtremeracing is offline  
Reply
Old 10-11-2017 | 01:19 PM
  #60  
VP of the tickfaw200
15 Year Member
 
Joined: Jul 2007
Posts: 2,124
Likes: 184
From: baton rouge, louisiana
Default

R3 just popped the hull out the mold for the kilo boat yesterday. looks like the same mold the race boats come fun just really cut down.
caseyh is offline  
Reply


Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.