Wanted: Set of speedmaster props
07-02-2003 | 08:36 AM
#2
KiloKat
Joined: Jun 2001
Posts: 971
Likes: 0
From: Edwardsville, IL
Check with John Tomlinson @ TNT. 305-931-3157
07-02-2003 | 09:07 AM
#3
Offshoreonly Advertiser
Joined: Mar 2001
Posts: 2,517
Likes: 280
From: Pompano Beach FL, USA
I have some,
954 545 8681
954 545 8681
__________________
Marc
www.mercruiserparts.com
www.go-fast.com
www.bammarine.com
www.cyborgtransmissions.com
It's not alive -www.BoatStuffExpress.com - temporarily retired
Marc
www.mercruiserparts.com
www.go-fast.com
www.bammarine.com
www.cyborgtransmissions.com
It's not alive -www.BoatStuffExpress.com - temporarily retired
07-03-2003 | 12:39 PM
#5
Guest
Posts: n/a
I have a pair in mint condition....three blade for a speedmaster drive...small shaft....17.5X28...just e-mail me if you are [email protected]
DMan
DMan
07-03-2003 | 02:00 PM
#7
Registered
Joined: Mar 2001
Posts: 3,881
Likes: 1
From: Monroe, LA
Ken:
I know you want a 6 inch hub, but don't worry about going to the short hub. I had a pair of bronze or brass (I forget which) spacers fabricated to go on behind the prop and in front of the nut so I could try a pair of 3-blades. Works fine. It was only about $40 to have them made. Not fre, but considering the 3-blade props cost about 1/3 as much as the 4-blades, it is cheap enough just to try a pair out.
P.S. -- Still had to go with the 4-blades.
I know you want a 6 inch hub, but don't worry about going to the short hub. I had a pair of bronze or brass (I forget which) spacers fabricated to go on behind the prop and in front of the nut so I could try a pair of 3-blades. Works fine. It was only about $40 to have them made. Not fre, but considering the 3-blade props cost about 1/3 as much as the 4-blades, it is cheap enough just to try a pair out.
P.S. -- Still had to go with the 4-blades.
Thread
Thread Starter
Forum
Replies
Last Post
fstboater
General Boating Discussion
1
04-20-2007 05:52 AM
