Right Angle (90 degrees) in exhaust
#5
Registered
Join Date: Jun 2006
Location: La Crosse, WI.
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
Re: Right Angle (90 degrees) in exhaust
I don't know where you are located at but me living in the dairy state have found allot of stainless steel piping at creameries, milk plants, cheese plants, Etc. they can only use there piping for so long and then have to discard it. I have never paid for my stuff. even if you do they prob will sell it for cheap.
good luck
good luck
#6
Registered
Re: Right Angle (90 degrees) in exhaust
Yes, remember that air is technically a fluid and fluid flow principles apply. Think of a garden hose with water running and kink a 90 vs a smooth radius. It also may cause more reversion if in an exhaust application. The fluid(air) along the edges is stagnant or actually moving in reverse slightly. The more radical the bend, the more stagnant fluid there is. There are some pretty sharp engineers on here who can explain it better than me.
#8
Registered
Re: Right Angle (90 degrees) in exhaust
We carry stainless smooth 90 degree bends also
http://www.cpperformance.com/detail.aspx?ID=4536
http://www.cpperformance.com/detail.aspx?ID=4536
#9
Registered
iTrader: (1)
Re: Right Angle (90 degrees) in exhaust
Do not use sharp 90° bends if you can help it. The longer, more sweeping you can make the turn, the better.
Think of a Winston Cup car trying to make a sharp 90 degree turn at the end of a straight a way.
Think of a Winston Cup car trying to make a sharp 90 degree turn at the end of a straight a way.
#10
Registered
iTrader: (1)
Re: Right Angle (90 degrees) in exhaust
Ooops. A Nextel Cup car too.
Thread
Thread Starter
Forum
Replies
Last Post
G Man
General Boating Discussion
35
10-22-2005 07:26 PM