Plate in riser of 496 manifolds...
#1
Gold Member
Gold Member
Thread Starter
iTrader: (5)
Join Date: Oct 2005
Location: Olmsted Falls,Ohio Marblehead,Oh
Posts: 11,634
Likes: 0
Received 204 Likes
on
132 Posts
Plate in riser of 496 manifolds...
Are these needed for sure? they look small, I thought I read they are not that critical, I want to see if I should run them or not..
#9
Registered
Join Date: Jun 2007
Posts: 55
Likes: 0
Received 0 Likes
on
0 Posts
as a non paying cheapo member I can't PM...
GoFastSonic or I DIG IT !! if you could contact me via E-mail [email protected] thanks!
Also, I read here that they are 'probably' there to help catch any condensation drip more than to combat reversion.
GoFastSonic or I DIG IT !! if you could contact me via E-mail [email protected] thanks!
Also, I read here that they are 'probably' there to help catch any condensation drip more than to combat reversion.
#10
Gold Member
Gold Member
Thread Starter
iTrader: (5)
Join Date: Oct 2005
Location: Olmsted Falls,Ohio Marblehead,Oh
Posts: 11,634
Likes: 0
Received 204 Likes
on
132 Posts
I ended up leaving them in for now, iw as told they are for condensation like staed above, I may experiment this summer, I will remove them and see if any gains happen if not I wiill put them back in to be safe, thanks for all the help!!