I don't know about the one your interested in but I still have the KPM unit available mentioned above. It's on ebay now. Look under member fireboatpilot items same as here on OSO.

I run the harden's and they work good, no wingnuts to drop in the bilage. Just make sure you put in shut off valves .

where can i find stainless fittings,,,,1-1/4in with threads on both ends,,,i need a fittings to go from sea strainer to ball valve,,,,catalogs dont show any???

I found all the stainless fittings I needed to plumb my strainer at Mainland Valve in Houston, TX. The rep I dealt with is Tim White. Stainless nipples are just a few bucks each. The contact info is:

MVF, Inc.

Mainland Valve and Fitting, Inc.

9031 Monroe Rd.

Houston, TX. 77061

1-866-894-4343

O - 713-910 6540

F - 713-910-6548

www.mainlandvalveandfitting.com

Can I add a flush kit to my existing Livorsi (Teague) 5" strainers? Will this allow me to flush particles out into the bilge while in the water?