Propshaft Runout ?
04-20-2002 | 09:26 AM
#1
Thread Starter
Registered
Joined: Jan 2001
Posts: 623
Likes: 2
From: Toledo Ohio Eubank Ky
Propshaft Runout ?
I was checking some TRS prop shafts (between centers in a lathe) and I was wondering if any of you Drive Builders could tell Me what is acceptable.One runs out .004 and one has .008 runout.
Rob
Rob
04-20-2002 | 10:10 AM
#2
Offshoreonly Advertiser
Joined: Mar 2001
Posts: 2,517
Likes: 280
From: Pompano Beach FL, USA
Rob, try and measure it with V blocks if you can. I assume it is straight between the races, then has a bend in what would be the prop portion. Supporting the shaft at the 2 races, measuring at the end of the prop shaft .004 is OK, .008 is marginal.
__________________
Marc
www.mercruiserparts.com
www.go-fast.com
www.bammarine.com
www.cyborgtransmissions.com
It's not alive -www.BoatStuffExpress.com - temporarily retired
Marc
www.mercruiserparts.com
www.go-fast.com
www.bammarine.com
www.cyborgtransmissions.com
It's not alive -www.BoatStuffExpress.com - temporarily retired
Thread
Thread Starter
Forum
Replies
Last Post
Formula Outlaw
Formula
4
05-16-2006 05:16 PM
