I do have large ovals and the mismatch is minimal because they are more of a roval shape.

Tinkerer- Missed the tall deck. I don't think they offer the pro FLO xt in a 10.2 configuration. Edelbrock discontinued the oval version of this because the two rear banks has distribution issues. The design of the rectangle port intake is different and wasn't affected. I spoke with several guys including Haxby about my setup and it was deemed a non issue. Try calling tech at edelbrock to see if they offer this in the 10.2 configuration. Sometimes they have as cast intakes for sale. I almost bought one to have Wilson port and finish before realizing that was a HUGE waste. Good luck!

Borgie, Do you happen to have the height measurement of your Pro Flo manifold from the bottom flat surface to the top? Im looking for a similar setup but can only go so high. Thanks!

9.9-10"?

If you can wait until this Friday, I will be back home and can check it when I arrive.

Total height is 10 ".

Perfect, thanks!

http://www.jegs.com/photos/300/350/3...arentPhoto.jpg

Thanks guys. My stock mpi 502 intake is 11 inches tall so this should fit no problem!
Haxby, I sent you a PM about EFI. Get back to me when you can. Thanks

I've looked at those alot. I really dig that manifold setup!

As far as the port match from the rectangle to roval, how significant is the mismatch? Do you have a pic with the intake mocked up?

www.precision-metalcraft.com


Posted this here before but will say a friend of mine had a bunch of time testing manifoilds and ended up using this for the Amsoil Engine Masters on his Pontiac. IMO very sharp looking as well.

.http://performancedesign.com/product/carbon-tr