Finally ready to install
#4
Registered
Thread Starter
Join Date: Jul 2002
Location: Hudson Valley
Posts: 375
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by mopower
Been there...done that
Good luck
Have they already been run and leak checked?
Been there...done that
Good luck
Have they already been run and leak checked?
thx gonna need alittle luck
#7
Registered
Thread Starter
Join Date: Jul 2002
Location: Hudson Valley
Posts: 375
Likes: 0
Received 0 Likes
on
0 Posts
what a nightmare
Got starboard side in, left the trannie on that one
will have to take off port trannie off to install.....
man no room whatsoever, 33 centers is tight wow.... i had to mill the gils down for clearance........extend the alt bracket it hits the manifolds.....i keep telling myself this is fun ...
i think i'm going to make a trap door under rear seat for easier access to the front of the motors.....
i'm gonna need a little help figuring out how to plumb the tee's
that sit on the front of the manifolds, i know the up side goes up to the riser , but do i connect the two water ports facing front to each other or block them off???????
Got starboard side in, left the trannie on that one
will have to take off port trannie off to install.....
man no room whatsoever, 33 centers is tight wow.... i had to mill the gils down for clearance........extend the alt bracket it hits the manifolds.....i keep telling myself this is fun ...
i think i'm going to make a trap door under rear seat for easier access to the front of the motors.....
i'm gonna need a little help figuring out how to plumb the tee's
that sit on the front of the manifolds, i know the up side goes up to the riser , but do i connect the two water ports facing front to each other or block them off???????
#9
Registered
Thread Starter
Join Date: Jul 2002
Location: Hudson Valley
Posts: 375
Likes: 0
Received 0 Likes
on
0 Posts
WoW , i fired up starboard motor tonight... the thing didn't miss a beat, very chrisp and strong, she is dialed....., i might just make it for next weekend.........
Thread
Thread Starter
Forum
Replies
Last Post
Mbam
New Products and Member Discounts
0
06-20-2008 06:35 AM
26scarab
General Boating Discussion
10
05-23-2002 01:53 AM