Procharger/ R-Tech Supercooler
10-20-2003 | 02:55 PM
#51
Registered
Joined: Feb 2001
Posts: 1,519
Likes: 31
Hi Kurt:
That 30 Bravo hardly knocked the RPM down at all. Paul needs to get a stock Bravo prop and try again next spring. It's too bad we couldn't get a hold of a 29 Mirage to try.
This is a layout of our SEMA booth. Paul's engine is going to be seen by thousands of people!
That 30 Bravo hardly knocked the RPM down at all. Paul needs to get a stock Bravo prop and try again next spring. It's too bad we couldn't get a hold of a 29 Mirage to try.
This is a layout of our SEMA booth. Paul's engine is going to be seen by thousands of people!
07-01-2018 | 04:47 PM
#56
Registered
Joined: Jul 2018
Posts: 1
Likes: 0
Help
We did some testing late in the day. The results! so far are nothing short of mind boggling!
The boat has been transformed into an animal!
tests so far have gained us 5 mph. last run was spinning a 28 Bravo 1 at 5500
next step will be jetting and fine tuning.
The stock Procharger M1 compressor went from 4.5 lbs boost to over 7.5 lbs in the manifold. Pretty impressive for just changing the intercooler/ carb box
A quick side note, the compressor discharge temps were 200+ degrees and after the intercooler, carb box temps were 86-88 degrees!!!!
....lake water was 70*
More results to follow.....We have not found the end of it
Kurt
The boat has been transformed into an animal!
tests so far have gained us 5 mph. last run was spinning a 28 Bravo 1 at 5500
next step will be jetting and fine tuning.
The stock Procharger M1 compressor went from 4.5 lbs boost to over 7.5 lbs in the manifold. Pretty impressive for just changing the intercooler/ carb box
A quick side note, the compressor discharge temps were 200+ degrees and after the intercooler, carb box temps were 86-88 degrees!!!!
....lake water was 70*More results to follow.....We have not found the end of it
Kurt
. I could really use some help thank you.
04-20-2020 | 05:36 PM
#57
Registered
Joined: Jul 2013
Posts: 265
Likes: 19
From: Mechanicsburg Pa./ Cape Coral FL
Just getting two of these units ready to put in my boat this summer, Talked to Tom, the lack of orders died in 2007. so the boxes made and sold from 2003 to to 2007 are the ones out there....454 mag with 680hp should be nice, the midrange power is what im looking for.
04-20-2020 | 08:49 PM
#59
Registered
Joined: Jan 2010
Posts: 617
Likes: 144
From: syracuse ny
Just getting two of these units ready to put in my boat this summer, Talked to Tom, the lack of orders died in 2007. so the boxes made and sold from 2003 to to 2007 are the ones out there....454 mag with 680hp should be nice, the midrange power is what im looking for.
