I was told how to this way,were the grease alimite thats in the top center of the transom plate,old style had a alimite there, new style has a sticker ontop of it,,but ya can see the hole were the sn# sticker covers it up,asuming thats center of the upper gimble pin/center line of input shaft,I used a dial caliper to ck the outside compared to the center of the alimite hole.it was within.060 thou,could of even been thicker paint.I am asuming its casted center? Then I checked the center of the prop shafts.I dont trust the center of the housing in the torepedo nose,being its a ruff casting and could be off,even the leading edge could be too.

If this makes a diff the B Max is around 13/16 further back and lower compared to a standard bravo.


Joe and Chip told me between 3/8 and 1/16,but that every boat likes it diff.Any sugestions?Rob

guts of a electric telescoping running light

Atleast I know whats in them

did it crap out?
was thinking of getting one.

got the board cut for the center cushion, going to the upholstery shop tommorow :

I carry the lights if anyone is in need!!

mine was not supported from the bottom,it cracked in a seam that was glued,the second one of my drunk Buddy's help it go down which striped out the zipper looking thingy on the inside, so I dissected it, the new one is built diff and is a led. real bright.If it goes out again I would buy another.Ck with Kirt,he'll hook ya up

finished my cushion last week, made it 1 foot longer, extends past the closet door, will hold 2 full size adults perfectly.

Jason heres the picks of the water pick ups we talked about,it looks like theres no way to mount it like Hustler told ya,imo you couldn't get the drain plug out.I placed it in the pick.Also I wrote down some mesurements,Maybe that will help ya, Im hopeing it not to much extra drag.

Rob -

Did anyone drill holes on the back seat arm rests for cup holders yet?

I will send them free cup holders!!!

Let me know.

I havent ,but the factory has,I have them allready in blue, and the girls need them, Im sacared ill f it up, maybe this summer,I have a air jig/hack saw that works pretty good, the carbon fiber works on it pretty hard on the blade.