Anyone out there have the hardware for a TRS sport engine hatch?
Looking for the two rear hinges and the front latches.
I know some of you are restoring / modifying some right now and if you happend to have that hardware available that would be great!
Thanks
Kevin

I will check,however the rear hinges are standard,the lock make be difficult...does it look like the one I have attached ?Bud

Thanks! My hatch is raised a bit in the rear.
The center ring piece I see on your picture looks correct.

Both Perko and Attwood make a hinge that is close. I will check it out when I am at the shop. Bud

Thriller Perko still makes the Rear Hatch Lifting Handel...# is )776 Flush Lifting Handel 3-3/4 X 2-3/4. should be available from West Marine special order,cost $45.00...hinges should not be a problem. Glad we could help,call me on wrapping your Mag. Bud

Perfect thanks for the help that takes care of the handle... Rear hinges are no problem, now I need the two latching mechanisms.... the push down and turn on each side of the hatch...
Thanks again!!!

Hey Cigret1!!! Why dont you get some scuba gear and go fish yours out!....hahahahahaha

Maybe the boys over at donzi.net know.......?......might be the same stuff?

I have a set of rear latches,they will have to be re-chromed...there is someone looking at the Maltese Hull,if he buys it I will check if needs them. He indicated he was not going to retro the 74.

Also some one was looking for a hull ...I might have one available if the person who I promised this one to first does not take it. Give me a call...312-607-3115

Awesome! I'll take them, Can you shoot me a message to my email so we can get each others contact info... [email protected]
Thanks for all the help