Gen 2`s out Gen 3 in
01-19-2007 | 05:43 AM
#81
Thread Starter
Registered User
Joined: Oct 2002
Posts: 2,260
Likes: 0
From: MIAMI WHERE ELSE
Re: Gen 2`s out Gen 3 in
Tomas, yes the two fingers holes are the dumps, its hot ofcourse, but it dumps it straight out. I have three methods of cooling the drive anyway. You can see in the picture on post 63 where the dump 90 degree fitting is, just about half way down the pipe.
01-19-2007 | 12:33 PM
#82
JC Performance Engines
Joined: Jul 2002
Posts: 8,904
Likes: 33
From: Long Island, NY
Re: Gen 2`s out Gen 3 in
albert... lookin good!
the manifold of the gen3 doesn't look much different from the gen2.
if you take the vid w/ a decent digital camera, you can email the file. that's the easiest way.
the manifold of the gen3 doesn't look much different from the gen2.
if you take the vid w/ a decent digital camera, you can email the file. that's the easiest way.
08-28-2008 | 06:27 AM
#89
Brotherhood #1
Joined: Sep 2006
Posts: 12,026
Likes: 111
From: Swansea Mass
So you have the intercooler dumping into the Manifold do you also have the engine water dumping in. Another question is can you fill the Elbo and Pipes seperatly with the 2 fittings at the bottom and dump them seperatly. It seems the last guy who had my set did that.
-Mike
-Mike
08-28-2008 | 04:05 PM
#90
Registered
Joined: Jul 2004
Posts: 1,229
Likes: 0
From: Stockholm, Sweden
So you have the intercooler dumping into the Manifold do you also have the engine water dumping in. Another question is can you fill the Elbo and Pipes seperatly with the 2 fittings at the bottom and dump them seperatly. It seems the last guy who had my set did that.
-Mike
-Mike
Sure, I suppose you can have separate dumps for manifolds and pipes since there are both inlets and outlets on both...
Last edited by tomas_wallin; 09-09-2008 at 01:23 PM.
