|
Originally Posted by Biggus
(Post 3648832)
Looking good! How think is the transom at the cut-out?
We were worried about the gimbal studs going all the way through due to the meat of this transom. But worked out fine. Not much threads to spare though. MD |
2.75"
|
Wicked cool . Keep slaving away.
|
Originally Posted by lil red
(Post 3648842)
2.75"
With the transom 2.75" you've lost .5" of input shaft engagement engagement. =Don't aske me how I know...had this issue years ago with a TRS boat. stripped out the splines in short time... Sorry to be the bearer of bad news but check the engagement. I had extended spline shafts made. Kurt |
Originally Posted by scarab63
(Post 3648816)
Attachment 471394
Attachment 471395 Attachment 471396 1.Cut the hole using this handy jig. Went conservative @ 17” X. Decided to keep it a bit lower, may sacrifice a couple mph, but dont want the prop blowing out in a hard corner racing etc..... 2. Once the holes cut, put some resin in to preserve the hole. 3. HP gimbal assy |
Originally Posted by Biggus
(Post 3648890)
I thought it looked extra thick. Industry standard is 2.25" when you make it thicker, you lose input shaft engagement into the coupler.
With the transom 2.75" you've lost .5" of input shaft engagement engagement. =Don't aske me how I know...had this issue years ago with a TRS boat. stripped out the splines in short time... Sorry to be the bearer of bad news but check the engagement. I had extended spline shafts made. Kurt |
Whats the status? You figure out your steering?
|
Making headway.
Steering is for sale in swap. Ordering imco system from teauge, rams mount 6.75” off gimbal |
Hows Combat Zone comming along? I forgot when the race is.......but isnt it comming up and will it be televised? Recent pic's? Jaime
|
Sold it
|
| All times are GMT -5. The time now is 11:00 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.