Powerplay 38 Hull ready for inside Lamination.

Powerplay 38 Hull Lamination

Powerplay 38 Hull Lamination we are placing pattern cut glass

Powerplay 38 Hull Lamination Setup Pedro is getting the Pressure fed roller together (it is taken apart when not used) the guys have placed a cardboard walkway on the side and behind the mold there is a pallet of cut fabric and in 15 minutes we start.

NOW WE'RE TALK'IN! BUILD PICS!


hey Steve those rollers you have, where is the catylist mixed at? How much maintenance are there on those and do you know of any for sale? So thats whats preferred over a wet out gun huh. cool stuff.

There is a trick to maintaining them, we would break it down and keep their lube on problem areas,You have three lines coming to the Block ,Resin , Mekp and Acetone then the valves,check valves and a long static mixer which went on the roller assembly .This style was superseded,

on the new systems a roller wand screws on the Gun, I had those overseas. I was using Venus "80" Guns in those days

Nothing beats a pressure fed roller in the right hands. Pedro has the block and static mixer ready to connect to the roller Via a quick disconnect fitting.

Steve, which guy are you in the pixs? Or are you behind the camera? Once again, great thread!

X-Driver, I am the one in the Grey shirt placing the glass here.

Why hand lamination? Is not infusion much better?

By Now yes!! For sure But one step at a time, Dan was doing a lot of Bagging there and the old Airex race boats were all up bagged.