top speed 280 silencer??

Reply Subscribe

Thread Tools

08-15-2007 | 01:11 PM

#11

CHAOS REIGNS

Thread Starter

Registered

Joined: Nov 2002

Posts: 641

Likes: 0

From: Huntersville, NC

for my 280 -- unless i have the motor at 4 or higher -- it never chine walks - i do have external add-a-ram hydraulic steering.

08-15-2007 | 02:24 PM

#12

runafever

Registered

Joined: Jun 2006

Posts: 718

Likes: 0

From: Medina Ohio

Quote:

Originally Posted by Dave98

RAF, You mentioned about "over trimming". I have a 300 Revenge. At speed, I have the tabs all the up and the motors at about 2-3. What is an indication of over trim? I have always adjusted the tabs and motors for max rpm but we have some what I would call serious chine walk at 75+ mph.

Thanks for any help or advice.

I'm not an expert on Powerquests hull and x and y dimensions of there drive placement but single engine step hulls will have more of a tendency to walk the dog on you than in a twin engine boat. I would try the oposite on a twin step revenge and at WOT try running your drives at 4 and your tabs at 2 and see if this settles the boat down some. Again it is a short hull.

08-19-2007 | 07:46 PM

#13

FITZ

Registered

Joined: Aug 2007

Posts: 2

Likes: 0

Have A 2002 Powerquest 28 With Bravo 1 4 Blade Runs 65mph No Chime Walk Has K Planes 490 Ho 425 Hp I Would Like To Go Faster What Prop Are Others Running

08-20-2007 | 11:46 AM

#14

pkspx

Gold Member

Joined: Sep 2003

Posts: 1,225

Likes: 2

From: Fort Lauderdale, FL

My 270 Laser has a built 454, running about 550hp out of it and use to chine walk before I did the IMCO 2" shorty. I got more top end and a better quaility of a ride. Side by side with my buddies boat I run 72mph.

08-21-2007 | 03:00 PM

#15

Pete280

Registered

Joined: Nov 2003

Posts: 867

Likes: 0

From: Virginia Beach, VA

Fitz, I have a labbed 26P Bravo, the previous owner also installed a 1" spacer on mine and picked up a couple mph. I have had mine to 69.5 gps with a 502, salt water