stumped?? picked up 800 rpms with 2" of pitch while heavier.
#11
Registered
Thread Starter
Thanks.. didn't read this until after I was pming you..
I agree, definitely need some more seat time and really run it.. trying not to run to hard with the kids.. but they did OK Sunday.. so they will just have to hold on! Lol
I agree, definitely need some more seat time and really run it.. trying not to run to hard with the kids.. but they did OK Sunday.. so they will just have to hold on! Lol
#12
Registered
Thread Starter
[ATTACH=CONFIG]503745[/ATTACH]
Or maybe the new radar arch is slowing me down!! Lol
Sorry sideways.. blame ios!!
Or maybe the new radar arch is slowing me down!! Lol
Sorry sideways.. blame ios!!
Last edited by nailit; 07-01-2013 at 08:04 PM.
#13
Registered
Thread Starter
4900 at 61 today with lighter load.. grabbed another 100 rpms.. also noticed the stock flame arrestors look pretty dirty..
I need to clean them, I wiped the grime off the fronts right before we left, but I bet the grime is deep in the screens.
Also was going to trying spinning in, but I may wait till I get my 25p props back on.
Slip increasing over 60... otherwise its at a respectible 9%!
I need to clean them, I wiped the grime off the fronts right before we left, but I bet the grime is deep in the screens.
Also was going to trying spinning in, but I may wait till I get my 25p props back on.
Slip increasing over 60... otherwise its at a respectible 9%!
#14
Registered
Thread Starter
Wow.. the flame arrestors were filty!! Couldn't even see daylight thru them!!
So, I got them off, cleaned, added nice purty new teal cup holders... so I probably need to put 30p on now right!!
Lol, at least it had to be restricting air flow at wot!! Will see next time out..
So, I got them off, cleaned, added nice purty new teal cup holders... so I probably need to put 30p on now right!!
Lol, at least it had to be restricting air flow at wot!! Will see next time out..