Not much progress with the boat in storage but I have been getting in some parts and finalizing new upholstery designs.

Eddie Marine Flush Port since I no longer use pickup on drive / Data ports so I can Plug into PDM, CD7 Dash, and AEM Infinity.

AEM INFINITY 308 STANDALONE ECU

AEM MEFI PNP Jumper kit for Infinity series 3 to MEFI 4

Prop should be close. I had a hopped up 575 in a 28' Advantage and I ran a 28" Bravo 1

She is out of storage and I am back to chipping off the list. I also decided to go with a MSD duel sync distributor over the winter to give the AEM a cam and crank signal as well as going with a coil near plug set up. Also decided that it would be a miss if I spent all this time with the rest of the boat but did not touch the interior so I contacted xt-innovations and had some new skins made. The quest continues !

Got a chance to install the helm and steering wheel.

Engine harness next.

did you repin the aem to mefi4 controller to mefi3 successfully or now that your adding CNP, did you just abandon the rest of the mefi harness?
im interested in seeing how that 5 blade handles , I tried countless props on my over powered 272 Baja and could never make a 5 blade work (boat would tq roll violently when you accelerated). Looking good overall, Smitty

Yeah i am just making my own harness now, would have to hack up the mefi harness too much. How much power were you making in you 272?

little safety net from dry startups and fluctuating oil pressure hopefully never need it

very nice

Engine sub harness done.