Back from the Dead; '81 Scarab 38 Resto
#911
VIP Member
VIP Member
Thread Starter
We’ll be over this hump soon guys. I went back and added filler to the deck in front of the hatches where there were some deep valleys. I’ve got the deck looking a lot better now. Probably gonna put some more slick sand on those areas tomorrow. Billy has sanded the entire trailer with 80 grit and it will probably be primed tomorrow.
The following 3 users liked this post by hblair:
#912
Registered
iTrader: (5)
Here’s what I’m talking about. This is outline left from where my stands were welded to my trailer crossmembers. It was welded all the way around on just about all of them. There was no rust in between there. Just bad rust from inside the square tubing. It would’ve been a lot better if they would have welded caps on the bottoms of the square tubing. But at one point do you stop on a boat trailer? LOL.
Plus this trailer was abused pretty bad, to be as new as it is...
Plus this trailer was abused pretty bad, to be as new as it is...
The following users liked this post:
hblair (05-16-2020)
The following 3 users liked this post by hblair:
The following 2 users liked this post by jeff32:
hblair (05-17-2020), larslindroth (05-18-2020)
The following 4 users liked this post by hblair:
larslindroth (05-18-2020), payuppsucker (05-18-2020), rak rua (05-17-2020), resurrected (05-19-2020)
The following users liked this post:
hblair (05-19-2020)
The following users liked this post:
hblair (05-19-2020)
#920
VIP Member
VIP Member
Thread Starter
Thanks guys, no gel coat Jeff, urethane primer and paint. I got the rest of the engine compartment sprayed yesterday. Been blocking on the deck. Deck should be in urethane primer Thursday...
Last edited by hblair; 05-19-2020 at 07:33 PM.
The following users liked this post:
larslindroth (05-21-2020)