Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 8
1
2
3
Last »
Search: Posts Made By: C.I.M.
Showing results 1 to 25 of 195
Search took 0.01 seconds.
Forum: Drives and Lower Units
04-01-2019, 08:43 PM
Replies: 12
Views: 5,140
Posted By C.I.M.

I have my performance report somewhere. i believe...

I have my performance report somewhere. i believe the x dimension is 22"
Forum: Drives and Lower Units
03-31-2019, 08:31 PM
Replies: 12
Views: 5,140
Posted By C.I.M.

I have an 07 42 lightning with 525's and ITS with...

I have an 07 42 lightning with 525's and ITS with std sportmasters. I modified the intakes on the 525s and had precision marine tune them. Blueprinted hull and lowers. Would regularly run 92-93 ...
Forum: General Boating Discussion
04-26-2017, 08:25 PM
Replies: 41
Views: 16,011
Posted By C.I.M.

There is something wrong with your performance...

There is something wrong with your performance report. If yours has staggered engines the 34" center is that of a side by side set up.
Forum: General Boating Discussion
04-23-2017, 08:24 PM
Replies: 41
Views: 16,011
Posted By C.I.M.

I have a 42. Same thing. Put your tabs to about...

I have a 42. Same thing. Put your tabs to about 5. Drives tucked all the way in. Once the props break loose let it rev to about 3500 and slowly start bringing the tabs back up. Try that seems to work...
Forum: General Boating Discussion
04-21-2017, 03:23 PM
Replies: 10
Views: 1,875
Posted By C.I.M.

Here's a look down the side that'll show the...

Here's a look down the side that'll show the metal flake effect a little better than the pictures. Watch in HD for best results.
https://www.youtube.com/watch?v=57oCLWv6wrw
Forum: General Boating Discussion
04-20-2017, 03:16 PM
Replies: 10
Views: 1,875
Posted By C.I.M.

Very nice job on this Matt. I really enjoyed...

Very nice job on this Matt. I really enjoyed talking with you about this project.
Thanks again,
Chad
Forum: Fountain
03-23-2017, 10:10 AM
Replies: 7
Views: 1,932
Posted By C.I.M.

Mine was right under the dash.

Mine was right under the dash.
Forum: Wanted
12-16-2016, 09:21 AM
Replies: 1
Views: 558
Posted By C.I.M.

525 efi valve covers

I need a mercury racing valve cover for a 525. I need the one that says mercury racing on it. blue. PM me if you have one.
Thanks,
Chad
Forum: General Boating Discussion
11-25-2016, 10:09 PM
Replies: 7
Views: 1,041
Posted By C.I.M.

I have a bunch pm me. Thanks

I have a bunch pm me.
Thanks
Forum: Drives and Lower Units
11-01-2016, 08:30 PM
Replies: 58
Views: 44,827
Posted By C.I.M.

I had him rebuild both of my drives this spring....

I had him rebuild both of my drives this spring. Put about 30 hrs on them over the summer and everything is still fine. Oil looks great. Very good guy to do business with.
Forum: General Q & A
07-25-2016, 11:57 AM
Replies: 12
Views: 8,230
Posted By C.I.M.

I believe the connector you are looking for is on...

I believe the connector you are looking for is on the inside of the plate the throttle cable mounts too.
Forum: Baja
07-17-2016, 09:33 AM
Replies: 18
Views: 9,053
Posted By C.I.M.

I had a 94 272 shooter. I put a 500 Efi and a...

I had a 94 272 shooter. I put a 500 Efi and a M3sc pro charger on it. It would run 85 all day long.
Forum: Electronics
07-06-2016, 12:41 PM
Replies: 4
Views: 785
Posted By C.I.M.

I did download the manual before I installed it. ...

I did download the manual before I installed it. If you go into the tank configuration it says there are "none" on the unused leads, but it still throws an error code when you turn the key on. I...
Forum: Electronics
07-05-2016, 09:51 AM
Replies: 4
Views: 785
Posted By C.I.M.

VV7 error codes on unused inputs

I just installed a VV7 in my 42 fountain with 525's. Every time I turn the key on to start it, it will run through a scan and come up with 7+ error messages then after a few seconds it will say...
Forum: General Q & A
06-14-2016, 09:19 AM
Replies: 0
Views: 595
Posted By C.I.M.

TPS Voltage for idle on a 525 efi?

Anyone know at what voltage on the tps sensor on a 525 it is out of the idle circuit.
Thanks,
Chad
Forum: Fountain
06-02-2016, 07:33 AM
Replies: 1
Views: 984
Posted By C.I.M.

Yes they are plastic. Use a cut off wheel an you...

Yes they are plastic. Use a cut off wheel an you will be fine. I cut one down on a 2000 35, and replaced one on a 09 38 express.
Forum: General Q & A
04-23-2016, 09:07 AM
Replies: 75
Views: 21,171
Posted By C.I.M.

Stock cam stock lifters. Isky Springs. Yes I did...

Stock cam stock lifters. Isky Springs. Yes I did increase plenum volume a lot. The hp curve technically never peaked. He said it did loose a very slight amount down low, but he said it was such a...
Forum: General Q & A
04-22-2016, 11:03 PM
Replies: 75
Views: 21,171
Posted By C.I.M.

Yes they were apples to apples.the were the...

Yes they were apples to apples.the were the uncorrected numbers. The weather was so good the correction wasn't changing it more than a couple hp. It made 40 hp more straight off the start. Then with...
Forum: General Q & A
04-22-2016, 07:00 PM
Replies: 75
Views: 21,171
Posted By C.I.M.

Yes it was from a dynoed engine.

Yes it was from a dynoed engine.
Forum: General Q & A
04-22-2016, 06:12 PM
Replies: 75
Views: 21,171
Posted By C.I.M.

Yes, We gained 61 hp over a stock 525. It would ...

Yes, We gained 61 hp over a stock 525. It would continue to make power until the hydraulic lifters would give up. Right around 6000 rpm. Getting ready to put them back in the boat and see what...
Forum: Swap Shop
03-14-2016, 10:25 PM
Replies: 7
Views: 756
Posted By C.I.M.

Sorry let me clarify. I'm looking for a standard...

Sorry let me clarify. I'm looking for a standard legnth sport master.
Forum: Swap Shop
03-13-2016, 04:29 PM
Replies: 7
Views: 756
Posted By C.I.M.

Want to trade short sportmaster lower for std.

I have a short sportmaster lower if anyone would be interested in trading for a standard. 1.5 gear.
Can email pictures if interested.
Forum: Wanted
02-28-2016, 09:46 PM
Replies: 0
Views: 495
Posted By C.I.M.

Wtb ITS top cap, rear cap, and driveshaft.

Building a spare drive. I need a top and rear cap for an its setup for tie bar. I also need the longer driveshaft. If anyone has one pm me.
Thanks.
Forum: Fountain
12-19-2015, 05:45 PM
Replies: 34
Views: 8,879
Posted By C.I.M.

Yes, gps and radar at the loto shootout. I spent...

Yes, gps and radar at the loto shootout. I spent a ton of time on setup on that boat. Lots of fun though.
Forum: Fountain
12-17-2015, 10:35 PM
Replies: 34
Views: 8,879
Posted By C.I.M.

My 2000 twin step with 500efis would run 93 with...

My 2000 twin step with 500efis would run 93 with labbed 32 bravo's. Props turning in.
Showing results 1 to 25 of 195
 
Page 1 of 8
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.