Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Broomes Isle Joe
Showing results 1 to 14 of 14
Search took 0.00 seconds.
Forum: General Q & A
08-22-2012, 01:08 PM
Replies: 18
Views: 14,653
Posted By Broomes Isle Joe

im sorry you did say that the boat is an 05 there...

im sorry you did say that the boat is an 05 there probably is a y fitting in the big hose from the thermastat hsng to the circulating pump your water feed hooks up to the bottom of the y fitting not...
Forum: General Q & A
08-22-2012, 12:35 PM
Replies: 18
Views: 14,653
Posted By Broomes Isle Joe

you really need to address your water issue first...

you really need to address your water issue first
the computer could be going into default mode cause of the high temp once you get the raw water pump corrected see if the rich condition still...
Forum: General Q & A
08-22-2012, 12:29 PM
Replies: 18
Views: 14,653
Posted By Broomes Isle Joe

fwc =fresh water cooling w/heat exchanger on...

fwc =fresh water cooling w/heat exchanger on front of motor if your in fresh water you probably dont have this
the check valves your talking about are most likely for a central drain system for...
Forum: General Q & A
08-22-2012, 08:39 AM
Replies: 18
Views: 14,653
Posted By Broomes Isle Joe

i dont believe there is an oil cooler on 350 mpi...

i dont believe there is an oil cooler on 350 mpi ,just p/s cooler
i would dissconnect outlet from sea pump and dissconnect water feed to therm housing put garden hose in hose flush back towards...
Forum: Drives and Lower Units
08-22-2012, 06:12 AM
Replies: 5
Views: 1,052
Posted By Broomes Isle Joe

see the [too much water pressure thread] in...

see the [too much water pressure thread] in general disscussion
you need a water pressure gauge plumbed to your block drain to monitor your pressure , did your old bravo have high or side water...
Forum: General Q & A
08-22-2012, 05:53 AM
Replies: 18
Views: 14,653
Posted By Broomes Isle Joe

temp sensors usually wont read unless there in...

temp sensors usually wont read unless there in water, if your sea pump failed u may not have been getting water to sensor
i would repair pump.backflush system if any impeller pieces are missing,...
Forum: General Boating Discussion
08-21-2012, 09:07 PM
Replies: 32
Views: 3,620
Posted By Broomes Isle Joe

Happy Birthday Eddie!!! thanks for your...

Happy Birthday Eddie!!! thanks for your help and guidance
you are definately a good example for anyone in the industry!!
Forum: Fountain
08-21-2012, 08:18 PM
Replies: 14
Views: 2,476
Posted By Broomes Isle Joe

the hose is held in with an internal plastic cone...

the hose is held in with an internal plastic cone shaped fitting ,that collapses from corrosion , most fountains have a ball valve shutting the water off to the drive when flushing so unless you...
Forum: Fountain
08-21-2012, 11:42 AM
Replies: 14
Views: 2,476
Posted By Broomes Isle Joe

you might want to check the fitting for the drive...

you might want to check the fitting for the drive water hose, you need to pull the feed hose for the rwp off of the transom fitting remove the 2 -7/16 head screws that attach the black plastic water...
Forum: Do It Yourself, Boating on a Budget
08-20-2012, 07:22 AM
Replies: 15
Views: 4,944
Posted By Broomes Isle Joe

with cool fuel the pressure loop is internal'pump...

with cool fuel the pressure loop is internal'pump ,cooler ,reg all in cool fuel mod `the regulated fuel line tees out to the rail,from between pump and reg, no fuel returns from the rail,the return...
Forum: General Q & A
08-18-2012, 02:31 PM
Replies: 8
Views: 997
Posted By Broomes Isle Joe

check the back for some reason i seem to remember...

check the back for some reason i seem to remember the ecm bracket attaching to 1 stud in 1 head and 1 stud in the back of the intake on the the other side it will have to come off anyway if you...
Forum: General Q & A
08-18-2012, 12:36 PM
Replies: 8
Views: 997
Posted By Broomes Isle Joe

a svc manual would be a very wise investment if...

a svc manual would be a very wise investment if your going to tear into this. the injector rail can be left in place but the rear ecm electronics bracket must come off before intake or heads will...
Forum: Do It Yourself, Boating on a Budget
08-18-2012, 06:57 AM
Replies: 15
Views: 4,944
Posted By Broomes Isle Joe

I have done several of these conversions and have...

I have done several of these conversions and have allways used same fuel rail, the regulator needs to be removed and install plug assy.merc# 22-860348a2 and o ring #25-805531 replacing the stock...
Forum: Sonic
08-03-2012, 07:22 PM
Replies: 6
Views: 1,342
Posted By Broomes Isle Joe

the 900sc #6 boat was special ordered from the...

the 900sc #6 boat was special ordered from the factory by a friend, ran 105 mph with 4 people all day long and had a generator, was featured in hotboat magazine in 98'I believe.was traded to the Va...
Showing results 1 to 14 of 14


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.