Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: wrath
Showing results 1 to 18 of 18
Search took 0.01 seconds.
Forum: General Boating Discussion
06-26-2023, 05:16 PM
Replies: 6
Views: 636
Posted By wrath

I believe it is in Gaurdian mode. It really will...

I believe it is in Gaurdian mode. It really will not rev over 1500 RPM but runs fine. It does start to sputter and run rough when we push it.
Forum: General Boating Discussion
06-26-2023, 12:21 PM
Replies: 6
Views: 636
Posted By wrath

thank you

thank you
Forum: General Boating Discussion
06-26-2023, 12:08 PM
Replies: 6
Views: 636
Posted By wrath

2002 - 496 Mag - will not rev over 1500 RPM

Hi All,
I need help. Three mechanics have thrown in the towel on this project.
I have a 2002 - 496 Mag non-HO. Engine was locked. Bought a Short block from boatnt on here. It was an extra for his...
Forum: Do It Yourself, Boating on a Budget
06-10-2021, 07:41 PM
Replies: 7
Views: 1,360
Posted By wrath

correct...no clickety click

correct...no clickety click
Forum: Do It Yourself, Boating on a Budget
06-10-2021, 07:40 PM
Replies: 7
Views: 1,360
Posted By wrath

I will be checking that this weekend...thank you...

I will be checking that this weekend...thank you for giving me some things to check. I will report back with what I find.
Forum: Do It Yourself, Boating on a Budget
06-09-2021, 08:33 PM
Replies: 7
Views: 1,360
Posted By wrath

2002 496 Mag Fuel Injectors not firing

Hello Again,
I am stumped on end of a two year project. I posted earlier about the Cam position sensor. Got the wiring and the conversion looks wired correctly.
I have what was a 2002 496 Mag 375...
Forum: Do It Yourself, Boating on a Budget
06-04-2021, 08:31 AM
Replies: 3
Views: 2,678
Posted By wrath

exactly what I was looking for

THANK YOU...THAT is EXACTLY what I needed!!!

such a simple reply to my long post!
Forum: Do It Yourself, Boating on a Budget
06-03-2021, 08:37 PM
Replies: 3
Views: 2,678
Posted By wrath

2002 496 Mag Cam position sensor question

Hello All,I am hoping I can get resolution for a two year project. (should not have taken that long but was trying to save money--not too successfully).
I have what was a 2002 496 Mag 375 hp engine...
Forum: General Q & A
04-05-2021, 11:28 PM
Replies: 3
Views: 580
Posted By wrath

496 Mag - New Engine Starts will not run

Hello everyone again,
I have posted several times. Baby steps. I purchased a 2002 - 28' Crownline a while back and the head gasket blew on the first outing. After a long and complicated ordeal that...
Forum: Drives and Lower Units
04-05-2021, 10:59 PM
Replies: 9
Views: 2,753
Posted By wrath

follow-up

Hello everyone,
I wanted to post a thank you for all the advice and provide a follow-up. There turned out to be a little more than expected with the outdrive. After taking the advice, I purchased...
Forum: Drives and Lower Units
11-13-2020, 06:55 PM
Replies: 9
Views: 2,753
Posted By wrath

Hello again everyone. This are all great...

Hello again everyone. This are all great suggestions and comments. This has become a DIY due to the cost of having it done at the shop. I have a friend that is a car mechanic that is helping me...
Forum: Drives and Lower Units
11-12-2020, 11:26 AM
Replies: 9
Views: 2,753
Posted By wrath

Bravo III outdrive Install question

Hello,
I have posted here before but have a new question. I purchased a 2002 Crownline 288BR last year. Wound up replacing the engine (long story). Now the new engine is in. Getting ready to put...
Forum: General Q & A
05-03-2020, 02:51 PM
Replies: 20
Views: 10,716
Posted By wrath

Thanks BUP and Boatnt

Boatnt and I contacted each other and I bought more than just his coil packs. I appreciate all the help on this forum!

Good to know about the knock-offs as well. I was on my way to making a...
Forum: General Q & A
05-02-2020, 03:47 PM
Replies: 20
Views: 10,716
Posted By wrath

496 Mag Coil packs D581 or D580

I was looking at replacing the coil pack on my 375 hp 496 Mag (2002) and saw this thread. However, my coil packs look like Delco Automotive D580 not the D581 (Square type but both the PCM plug and...
Forum: Do It Yourself, Boating on a Budget
07-25-2019, 07:06 PM
Replies: 24
Views: 4,969
Posted By wrath

Thank you AllDodge! I appreciate the help! ...

Thank you AllDodge!

I appreciate the help!

Maybe I can get back on the water this weekend! :)

Again..Thank you AltDodge...I have the CPS coming from RockAuto. You confirmed what I was...
Forum: Do It Yourself, Boating on a Budget
07-25-2019, 06:38 PM
Replies: 24
Views: 4,969
Posted By wrath

Thank you AllDodge! I appreciate the help! ...

Thank you AllDodge!

I appreciate the help!

Maybe I can get back on the water this weekend! :)

Again..Thank you AltDodge...I have the CPS coming from RockAuto. You confirmed what I was...
Forum: Do It Yourself, Boating on a Budget
07-25-2019, 04:15 PM
Replies: 24
Views: 4,969
Posted By wrath

Thank you for the response. I did not mean to...

Thank you for the response. I did not mean to step on any toes. I thought this was a forum to for boaters to ask questions. I am new to this forum and did not know I even mentioned a competitor.
I...
Forum: Do It Yourself, Boating on a Budget
07-24-2019, 06:48 PM
Replies: 24
Views: 4,969
Posted By wrath

2002 Mercruiser 496 Mag CPS question

All,

I am new to this forum but wanted to reach out. I just bought a boat with a 2002 496 Mag Base model Bravo III outdrive. Serial Number M084202

The head gaskets went out on my first outing....
Showing results 1 to 18 of 18


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.