Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: 26ZX Donzi
Showing results 1 to 25 of 242
Search took 0.07 seconds.
07-05-2019, 10:58 AM
Replies: 15
Views: 3,588
Posted By 26ZX Donzi

Thank You All!!

Thank You All!!
07-05-2019, 09:22 AM
Replies: 15
Views: 3,588
Posted By 26ZX Donzi

So even if the motor is empty you replace all the...

So even if the motor is empty you replace all the fluid through the coolant tank? No worries about air in the system doing it that way?
07-04-2019, 08:49 AM
Replies: 15
Views: 3,588
Posted By 26ZX Donzi

Engine is a 525 with serial number 91004981. ...

Engine is a 525 with serial number 91004981. Would like to finish putting it together today or tomorrow and use it for the weekend but I do not want to trap air in the block if that’s an issue....
07-03-2019, 04:55 PM
Replies: 15
Views: 3,588
Posted By 26ZX Donzi

Anyone have a service manual that they can share...

Anyone have a service manual that they can share the procedure please?
07-03-2019, 12:29 PM
Replies: 15
Views: 3,588
Posted By 26ZX Donzi

Regret to say I do not have a service manual. I...

Regret to say I do not have a service manual. I did drain the block as well however I am not sure on the official refill procedure.
07-03-2019, 10:09 AM
Replies: 15
Views: 3,588
Posted By 26ZX Donzi

525 Coolant Change

Drained most if not all fluid out of closed cooling on my 525 EFI. A couple questions: Should I use the 50/50 diluted Dex Cool to refill or mix my own concentrate with distilled water at a higher...
Forum: General Q & A
06-24-2019, 10:53 AM
Replies: 6
Views: 768
Posted By 26ZX Donzi

Once I remove fuel lines to take this all apart...

Once I remove fuel lines to take this all apart will I need to bleed fuel system somehow? Is there a rebuild kit for these Gen V seals/bearings? Thanks
Forum: General Q & A
06-24-2019, 08:52 AM
Replies: 6
Views: 768
Posted By 26ZX Donzi

Any ideas?

Any ideas?
Forum: General Q & A
06-23-2019, 10:50 AM
Replies: 6
Views: 768
Posted By 26ZX Donzi

525 Sea Pump Weep Hole

Have a 2008 525EFI in our Sunsation with a Hardin Marine Stainless pump body. Replaced the impeller, wear plates and the two O-rings and noticed that there was a slight leak. Water was coming out...
Forum: Wanted
10-07-2015, 07:50 PM
Replies: 0
Views: 238
Posted By 26ZX Donzi

Livorsi 2" clock needed

Looking for a 2" black face, silver rim clock. Livorsi no longer carries or repairs them. Any leads greatly appreciated.
10-07-2015, 07:31 PM
Replies: 1
Views: 387
Posted By 26ZX Donzi

Livorsi 2" clock needed

Clock bit the dust and Livorsi does not sell or repair the 2" version anymore. It has a black face and silver rim. It is in the open bow of the boat so another motor based gauge makes no sense. ...
08-25-2015, 08:43 AM
Replies: 5
Views: 897
Posted By 26ZX Donzi

Here right now and have boated from Party Cove...

Here right now and have boated from Party Cove and then back up to Bagnell Dam. Have not gone toward race course yet, but this end of lake is perfect - no debris spotted.
08-09-2015, 08:19 PM
Replies: 10
Views: 2,079
Posted By 26ZX Donzi

The boat currently has the Corsa 5" Big Gun tips...

The boat currently has the Corsa 5" Big Gun tips on it so I don't believe I could put the Shotguns on over that tip. I assume that is how this piece works. I do like the idea of the Shotguns...
08-09-2015, 11:22 AM
Replies: 10
Views: 2,079
Posted By 26ZX Donzi

Cool Exhaust tips - noise reduction

Searched all through site and looked all over yet cannot find much definitive first person reports on what works best. I have a 525 that is stock other than the computer upgrade done by Ozark...
06-16-2015, 02:38 PM
Replies: 13
Views: 2,128
Posted By 26ZX Donzi

Love the boat on Craigslist, but cannot stomach...

Love the boat on Craigslist, but cannot stomach $139,000 for a single engine black motor boat!
06-14-2015, 04:41 PM
Replies: 13
Views: 2,128
Posted By 26ZX Donzi

Still looking - any leads?

Still looking - any leads?
Forum: Sunsation
05-17-2015, 09:10 PM
Replies: 2
Views: 1,088
Posted By 26ZX Donzi

Looking for 288 MCOB

Still looking for a 2005 or newer 288 MCOB. Put a thread in main section without much luck. Any owners or friends of owners know of one for sale?

Tim Fitzgerald
847-404-2426
Forum: General Q & A
05-17-2015, 12:59 PM
Replies: 2
Views: 510
Posted By 26ZX Donzi

496ho Impeller question

I have a 2008 Formula 260BR with a 496 HO and I am not getting any water flow thru exhaust since winterization. I had the impeller and Housing Cover (863674a04) replaced 9/13. I have no doubt the...
05-16-2015, 10:29 AM
Replies: 13
Views: 2,128
Posted By 26ZX Donzi

Thanks Feverz - you being in Michigan may have...

Thanks Feverz - you being in Michigan may have the opportunity to see more 288's.
05-15-2015, 07:14 PM
Replies: 13
Views: 2,128
Posted By 26ZX Donzi

That is what I thought at first as well. If you...

That is what I thought at first as well. If you look closer several powerboat ads are 5 years old on their site. Additionally there is only one MCOB that is newer that is actually for sale and it...
05-15-2015, 11:13 AM
Replies: 13
Views: 2,128
Posted By 26ZX Donzi

Still looking - not much out there that I can...

Still looking - not much out there that I can find. Anyone?
05-08-2015, 01:47 AM
Replies: 13
Views: 2,128
Posted By 26ZX Donzi

WTB: Sunsation 288 MCOB

Looking for a well maintained Sunsation 288 MCOB. Only interested in 2005 or newer. Tim 847-404-2426
Forum: Sunsation
05-02-2015, 10:52 PM
Replies: 35
Views: 10,706
Posted By 26ZX Donzi

I am in the market for a 288 MCOB. Please send...

I am in the market for a 288 MCOB. Please send me any info on your boat for sale - can also send pics/text to 847-404-2426. Thanks - Tim Fitzgerald
08-20-2014, 11:29 AM
Replies: 25
Views: 3,937
Posted By 26ZX Donzi

Been caught doing same thing on the lake in my...

Been caught doing same thing on the lake in my former Donzi 35ZR. As you said it is doable for you, but my passengers were very uneasy to say the least. I am an Air Traffic Controller at ORD and...
07-07-2014, 09:20 PM
Replies: 33
Views: 5,596
Posted By 26ZX Donzi

All I can say is Thank You Gino. We all live...

All I can say is Thank You Gino. We all live vicariously through your exploits and it always brings a smile. I also think it is great how you can laugh at yourself and just move on. :)
Showing results 1 to 25 of 242
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.