Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 8
1
2
3
Last »
Search: Posts Made By: russ
Showing results 1 to 25 of 194
Search took 0.01 seconds.
Forum: General Q & A
08-30-2005, 09:19 AM
Replies: 4
Views: 2,175
Posted By russ

Re: no bow lift

You might look at these spots. Some manufactures might also put them into other areas. But this will give you an idea where to look.
Forum: Baja
07-25-2005, 09:02 PM
Replies: 21
Views: 5,152
Posted By russ

Re: leaning issue again!

FX10

I could see that I would have this issue if I had a motor putting out that kind of horse power but this lean issue was happening when I had the 6.2 merc in it 320 hp in this boat shouldn't...
Forum: Baja
07-25-2005, 08:52 PM
Replies: 21
Views: 5,152
Posted By russ

Re: leaning issue again!

Ok this confuses me more. My boat will always lean port side down. Never changes. Now going by what you are saying if wind hits me on the port side that should off set the torque if that is what is...
Forum: Baja
07-25-2005, 08:42 PM
Replies: 21
Views: 5,152
Posted By russ

Re: leaning issue again!

recovering,

If you don't have anything use full to add SHUT UP!
Forum: Baja
07-25-2005, 09:06 AM
Replies: 21
Views: 5,152
Posted By russ

Re: leaning issue again!

Dock,

Does yours lean both ways in the wind? Mine doesn't.

As for torque streer this was doing it with the 6.2 merc in it. And it didn't get any worse when I added the 502 its just the same.
...
Forum: Baja
07-22-2005, 07:59 PM
Replies: 21
Views: 5,152
Posted By russ

Re: leaning issue again!

Which side does he think is causing the problem port or starboard or combination of both? Mine to leans slightly to the port side always they told me it was prop torque.(drives me nuts) But with wind...
Forum: Baja
07-21-2005, 11:13 PM
Replies: 21
Views: 5,152
Posted By russ

Re: leaning issue again!

dsandman6

So the people you talked to said the lean might be caused by the bottom? And when you say slight lean is it there always or just in certain conditions. Mine the slight lean is always...
Forum: General Q & A
07-21-2005, 04:35 PM
Replies: 0
Views: 2,723
Posted By russ

Hull issue? Torque issue? Weight issue?

Posted else where but didn't get much response so decided to post here. More traffic.

Have a single engine 02 252 Baja islander.

Problem is boat leans extreamly bad to the port side when heavy...
Forum: Baja
07-21-2005, 10:42 AM
Replies: 21
Views: 5,152
Posted By russ

Re: leaning issue again!

I know some of the lean could be caused by engine torque. But I was running with some other Baja's last week when it was really windy. I talked with them when we tied up. One was a 272 and one was a...
Forum: Baja
07-20-2005, 07:03 PM
Replies: 21
Views: 5,152
Posted By russ

Re: leaning issue again!

No one else has this issue with there Baja leaning hard into the wind on the port side when it's windy? And no leaning at all on the starboard side when the wind hits hard on that side?

If no one...
Forum: Baja
07-20-2005, 09:24 AM
Replies: 21
Views: 5,152
Posted By russ

Re: leaning issue again!

Talked with Baja the dealer and another person that does bottom work that has no ties with Baja and all said it was meant to be in there. If I wanted it out I would have to pay for it and the affect...
Forum: Baja
07-19-2005, 04:32 PM
Replies: 21
Views: 5,152
Posted By russ

leaning issue again!

Still working on this problem. Went to the dealer when it wasn't a windy day. And the boat leaned a little bit but told it was normal (engine torque). Talked to them again about getting a left hand...
Forum: Detailing, Painting, & Fiberglass
07-08-2005, 10:31 AM
Replies: 55
Views: 49,721
Posted By russ

Re: Transom replacement gone wrong

Jackhammer,

Which company did U use that went belly up? If you wanted to still have someone do it U might call 214-679-1089 the guy's name is Joe. He has a shop over in Denton area. Unless he's...
Forum: Prop Talk
05-31-2005, 12:32 PM
Replies: 9
Views: 8,317
Posted By russ

Re: Baja 232 Prop ??

check your tach. Had the same motor in my 02 252 islander. would spin the 19p to 4900 rpm's.
And mine was running 56 to 59 gps depending on conditions.

Are you sure it's a 19P? U might borrow...
Forum: General Boating Discussion
05-20-2005, 11:50 PM
Replies: 28
Views: 3,076
Posted By russ

Re: Box anchor group buy ends 5/20/05

This Group Buy Is Over. Hope All That Got One Or Two Like Them!!
Forum: General Q & A
05-20-2005, 03:48 PM
Replies: 9
Views: 6,985
Posted By russ

Re: drilled a hole and some water came out?

From what I could tell is the chips from the holes where water came out were wet. None of the others. The closest thing that water could have gotten into the transom is 18 inches away.

Good thing...
Forum: General Q & A
05-20-2005, 12:51 PM
Replies: 9
Views: 6,985
Posted By russ

Re: drilled a hole and some water came out?

Why would water only come out of one hole. The holes run down the V in a straight line. The one below it didn't leak and the shavings that came out of the other holes wasn't wet.

Russ
Forum: General Boating Discussion
05-20-2005, 10:19 AM
Replies: 28
Views: 3,076
Posted By russ

Re: Box anchor group buy ends 5/20/05

last day
Forum: General Q & A
05-19-2005, 11:12 PM
Replies: 9
Views: 6,985
Posted By russ

drilled a hole and some water came out?

In the process of installing my Victory trim tabs on my Baja 252 islander.
Well I drilled the holes to mount the tabs and in just one hole water started comming out but not a lot. But nothing came...
Forum: General Boating Discussion
05-19-2005, 10:18 AM
Replies: 28
Views: 3,076
Posted By russ

Re: Box anchor group buy ends 5/20/05

Thursday and Friday are your last days to buy at this discount.
Forum: Baja
05-18-2005, 12:30 PM
Replies: 2
Views: 2,641
Posted By russ

trim tab mounting

Going to be mounting trim tabs on my 252 islander. Have a call into the Baja dealership but thought I would ask here to.
What are the measurements to mount the tabs? Basically how do you know where...
Forum: General Boating Discussion
05-18-2005, 07:10 AM
Replies: 28
Views: 3,076
Posted By russ

Re: Box anchor group buy ends 5/20/05

You would save around $35.
Forum: General Boating Discussion
05-17-2005, 09:59 AM
Replies: 28
Views: 3,076
Posted By russ

Re: Box anchor group buy ends 5/20/05

The small works well for me. I have a 25' boat.

(Baby) Personal watercraft
(Small) Offshore / Sport 18' to 30', cabin cruiser to 24'
(Large) Offshore / Sport to 40', cabin cruiser to 32' ...
Forum: General Boating Discussion
05-17-2005, 08:46 AM
Replies: 28
Views: 3,076
Posted By russ

Re: Box anchor group buy ends 5/20/05

ttt
Forum: General Boating Discussion
05-15-2005, 12:20 PM
Replies: 28
Views: 3,076
Posted By russ

Re: Box anchor group buy ends 5/20/05

You'll have to call him on the swim step.
Ryan Dvorak
Phone #1-805 493 9073
Showing results 1 to 25 of 194
 
Page 1 of 8
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.