Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: In the red
Showing results 1 to 25 of 39
Search took 0.00 seconds.
Forum: General Q & A
04-26-2018, 07:43 AM
Replies: 10
Views: 3,545
Posted By In the red

Very easy nighthawk. Take the one bolt off each...

Very easy nighthawk. Take the one bolt off each end and use a small screwdriver to pry the cap and gasket off. In mine the pieces (and a little lake grass) were in the water inlet end (port side of...
Forum: General Q & A
04-25-2018, 03:10 PM
Replies: 10
Views: 3,545
Posted By In the red

Follow up report.......Problem was the gaskets on...

Follow up report.......Problem was the gaskets on both the ends of the heat exchanger. Both were deteriorated and sucking into the water tubes causing a restriction. Easy to change and all pressures...
Forum: General Q & A
04-23-2018, 11:09 AM
Replies: 2
Views: 1,815
Posted By In the red

I am working on a high pressure alarm on my 496's...

I am working on a high pressure alarm on my 496's right now that use that same sensor. My alarm trips at 41 psi at WOT on a Rinda scanner. Im not sure what the Merc spec is. My other motor runs at 35...
Forum: General Q & A
04-23-2018, 10:37 AM
Replies: 10
Views: 3,545
Posted By In the red

Thanks BUP and others for your quick response on...

Thanks BUP and others for your quick response on a Sunday morning so I had time to work on the boat. Inlet side of the oil cooler had quite a bit of fine brown sea grass in it. I cleaned all that...
Forum: General Q & A
04-22-2018, 09:41 AM
Replies: 10
Views: 3,545
Posted By In the red

496HO Sea Pump/Block pressure high on Rinda Techmate Pro

2005 496HO with closed cooling. When reading live data with the boat running at WOT my block pressure occasionally goes over 40 psi and trips the two beeps on Smartcraft. This only happens at WOT and...
Forum: General Boating Discussion
11-15-2017, 06:28 PM
Replies: 36
Views: 7,469
Posted By In the red

Jason, Sent a PM. Thanks!

Jason, Sent a PM. Thanks!
Forum: Wanted
08-08-2016, 07:47 PM
Replies: 0
Views: 373
Posted By In the red

WTB Pair of 20p or 21p Rev 4's or Q4's

Merc Rev 4's are available in 20 or 21 pitch. Quicksilver Q4's are available in 21 pitch. What do you have? Must be nice clean props. PM me please.
Forum: Wanted
10-18-2013, 07:58 AM
Replies: 0
Views: 406
Posted By In the red

Bravo I, X, or XR lower case only Dual Water Pick-up

I need the case only. Freshwater only please. Mine is a 2006 dual water pickup.(sides and nose both) I believe the merc part number is 1656-8866A64. According to my chart this case was used in most...
Forum: Poker Runs and Boating Events
05-29-2013, 06:26 AM
Replies: 25
Views: 4,649
Posted By In the red

Only 9 days away. Looking forward to seeing...

Only 9 days away. Looking forward to seeing everyone again this year! :daz:
Forum: Donzi
05-22-2013, 10:38 AM
Replies: 19
Views: 10,351
Posted By In the red

Thanks. PPI in Sarasota did it. Complete new...

Thanks. PPI in Sarasota did it. Complete new redesigned side panels and all new foam and vinyl. Great guys to work with and their quality is second to none.
Forum: Donzi
05-21-2013, 05:53 PM
Replies: 19
Views: 10,351
Posted By In the red

Josh, I went from a 2005 Stingray 230SX with a...

Josh,
I went from a 2005 Stingray 230SX with a 496HO to a 2006 28ZX with twin 350 mag mpi's. It was the best decision I ever made and love the Donzi. I have had it since 2008. Mine has the plexi...
Forum: Donzi
04-28-2013, 08:07 AM
Replies: 67
Views: 32,075
Posted By In the red

Thanks Fixx. I have kicked that around from time...

Thanks Fixx. I have kicked that around from time to time but if I remember correctly the most pitch they offer is a 25, and I didnt think that was enough.
Forum: Donzi
04-24-2013, 08:42 PM
Replies: 67
Views: 32,075
Posted By In the red

Should have posted on this one earlier but...

Should have posted on this one earlier but haven't been on the forums much.
2006 28ZX with 350 mag mpi's and 1.65 bravos from the factory. Also have factory K-planes.
Drives measure 6 3/4 bottom 6...
Forum: Donzi
10-01-2012, 11:43 AM
Replies: 19
Views: 9,508
Posted By In the red

My 2006 28 with 350's is most efficient at 3400...

My 2006 28 with 350's is most efficient at 3400 RPM which is 44-45mph as Vette said. A friend of mine loaned me his Diacom software and cable so I could run my laptop on the boat. Best fuel economy...
Forum: Poker Runs and Boating Events
07-07-2012, 07:41 AM
Replies: 109
Views: 16,907
Posted By In the red

Thanks John!!! We are up to 11 boats coming from...

Thanks John!!! We are up to 11 boats coming from Lake Murray. See you soon.
Forum: Donzi
06-27-2012, 04:24 PM
Replies: 330
Views: 333,028
Posted By In the red

http://img542.imageshack.us/img542/6323/durun2012....

http://img542.imageshack.us/img542/6323/durun2012.jpg (http://imageshack.us/photo/my-images/542/durun2012.jpg/)

Helo shot by Performance Images at our Ducks Unlimited Poker Run a couple of weeks...
Forum: Poker Runs and Boating Events
06-27-2012, 02:02 PM
Replies: 109
Views: 16,907
Posted By In the red

John, Are you going to post the stops and GPS...

John, Are you going to post the stops and GPS coordinates so we can get our GPS's programmed? I didn't see them on the web site, but maybe I'm missing it... Thanks. Jim/Lake Murray Powerboats
Forum: Poker Runs and Boating Events
06-22-2012, 06:53 PM
Replies: 57
Views: 11,356
Posted By In the red

John, Are you going to post the stops and GPS...

John, Are you going to post the stops and GPS coordinates so we can get our GPS's programmed? I didn't see them on the web site, but maybe I'm missing it... Thanks.
Forum: General Boating Discussion
03-09-2012, 08:23 AM
Replies: 164
Views: 64,580
Posted By In the red

+1!

+1!
Forum: Donzi
03-04-2012, 08:53 PM
Replies: 47
Views: 25,103
Posted By In the red

Don't want to hijack but Vette, I just got my 26...

Don't want to hijack but Vette, I just got my 26 bravos back from being worked by BBlades. We will see.........
Forum: Donzi
03-04-2012, 08:44 PM
Replies: 47
Views: 25,103
Posted By In the red

2006 28 ZX here and I love it. (same hull as the...

2006 28 ZX here and I love it. (same hull as the ZXO) I have had 13 boats and this is probably the best riding and handling hull of all of them. We live on a lake and use it every weekend from April...
Forum: Poker Runs and Boating Events
03-03-2012, 05:55 AM
Replies: 19
Views: 5,139
Posted By In the red

Can't wait!

Can't wait!
Forum: Poker Runs and Boating Events
03-31-2011, 01:19 PM
Replies: 19
Views: 4,374
Posted By In the red

Best weekend on the lake last year. Enjoyed...

Best weekend on the lake last year. Enjoyed meeting all the out of town folks and seeing their rides. We are looking forward to this years event being larger and even and more fun!
Forum: General Boating Discussion
06-30-2010, 07:15 PM
Replies: 17
Views: 4,306
Posted By In the red

It was good meeting you Mike. Appreciate the tip...

It was good meeting you Mike. Appreciate the tip on the Donzi vinyl.
Jim
Forum: General Boating Discussion
06-28-2010, 08:51 PM
Replies: 17
Views: 4,306
Posted By In the red

Great job with the pics, Lee. It was quite a...

Great job with the pics, Lee. It was quite a weekend. Its going to take me till Friday to recuperate and then its the 4th and its back on the water! :drink:
Showing results 1 to 25 of 39
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.