Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: Kid Cumberland
Showing results 1 to 25 of 38
Search took 0.01 seconds.
Forum: General Q & A
09-22-2015, 10:48 AM
Replies: 16
Views: 2,052
Posted By Kid Cumberland

Who does good job on Carburetor Rebuilds?

Hey All,
Looking for someone to clean and rebuild my carb from a 525SC please. Any recommendations would be greatly appreciated.
Thanks!
Forum: General Q & A
06-22-2011, 03:32 PM
Replies: 4
Views: 723
Posted By Kid Cumberland

Help! Smoke on the Water!

Hey all!
Hope everyone is enjoying burning some gas this summer! So I was putting my boat in on a dark night last weekend. It was dark, and still have some debris on Cumberland so I was running...
Forum: General Q & A
06-22-2011, 03:22 PM
Replies: 13
Views: 3,860
Posted By Kid Cumberland

V-Twin

I picked up off of here a couple of years ago that Mobil 1 V-Twin oil had the best overall performance numbers. Being as this oils is designed to operate in the harshest conditions (air cooled HD)...
Forum: General Q & A
08-18-2010, 12:51 PM
Replies: 2
Views: 1,023
Posted By Kid Cumberland

26 views and no answers!?!

Someone had to have run into this along the line. Still looking for some guidance. Thanks All.
Forum: General Q & A
08-16-2010, 03:00 PM
Replies: 2
Views: 1,023
Posted By Kid Cumberland

Airpax Switch boots. Help Please!!

Hello All,
Ok so I have a mystery here. I have a 1996 Fountain and my blower breaker switch went out. So after much searching I found a matched replacement off of ebay. Here is the strange part. ...
Forum: General Q & A
04-27-2010, 10:18 AM
Replies: 18
Views: 13,886
Posted By Kid Cumberland

I think I better check my boost gauge first. I...

I think I better check my boost gauge first. I dont start making any boost on the gauge until about 3500 RPM. Is this normal? Anyone have a good method for testing the gauge?
Thanks in Advance.
Forum: General Q & A
04-24-2010, 06:59 PM
Replies: 18
Views: 13,886
Posted By Kid Cumberland

Im not sure if its something that just started...

Im not sure if its something that just started happening Griff. I dont recall that much boost last fall but I only had it for a few runs. I did the top end rebuild this winter but used all stock...
Forum: General Q & A
04-22-2010, 02:36 PM
Replies: 18
Views: 13,886
Posted By Kid Cumberland

Hey all Please don't pass up on this thread...

Hey all Please don't pass up on this thread because of this answer. Thanks Blue Thunder but it doesn't really answer my question. Just looking to find out what the stock set-up was. Griff??
Forum: General Q & A
04-22-2010, 10:43 AM
Replies: 18
Views: 13,886
Posted By Kid Cumberland

Weiand 177 Blower Pulley Size

Hey All,
I have a boat with a 525 SC Motor and the dash gauge is showing its making 8 to 8.5 lbs of boost at WOT (5200 RPM). From what I understand this is higher than the stock boost. Trying to...
Forum: General Q & A
03-18-2010, 11:23 AM
Replies: 15
Views: 2,307
Posted By Kid Cumberland

Royal Purple gear oil.

Royal Purple gear oil.
Forum: General Q & A
03-18-2010, 11:19 AM
Replies: 11
Views: 6,727
Posted By Kid Cumberland

Thanks Steve and all for your responses. The...

Thanks Steve and all for your responses. The sound of a Vinyl wrap is sounding better and better by the day.
Forum: General Q & A
03-16-2010, 06:37 PM
Replies: 11
Views: 6,727
Posted By Kid Cumberland

So no on the Multistrip stuff that is supposwed...

So no on the Multistrip stuff that is supposwed to be safe on Gel coats?
Forum: Fiberglass and Paint
03-16-2010, 06:36 PM
Replies: 10
Views: 14,683
Posted By Kid Cumberland

Yeah but as Reggie would say.. "I got the...

Yeah but as Reggie would say.. "I got the fastest lipstick and jade boat on the lake big boy!"
Forum: Fiberglass and Paint
03-16-2010, 05:13 PM
Replies: 10
Views: 14,683
Posted By Kid Cumberland

What if you just want to go down to white and not...

What if you just want to go down to white and not redo any graphics? After you sand it off can it just be buffed to white?
Thanks in advance.
Forum: General Q & A
03-16-2010, 05:07 PM
Replies: 11
Views: 6,727
Posted By Kid Cumberland

Imron Paint Removal

Hey All,
Anyone had any experience with removing Imron paint graphics from a boat? Working on a 95 Fountain. Just want to get down to white. Pretty sure it can be sanded and buffed but was...
Forum: General Q & A
03-04-2010, 04:26 PM
Replies: 1
Views: 569
Posted By Kid Cumberland

Looking for an intercooler for a 525SC

Hey All,
Was hoping someone had an intercooler for a 525sc Laying around. Looking for a used one cause Im way over budget on this project and it all yalls fault ! haha
Forum: General Q & A
03-04-2010, 02:59 PM
Replies: 41
Views: 5,255
Posted By Kid Cumberland

My Bad. Yall must be talkin about WOT timing.

My Bad. Yall must be talkin about WOT timing.
Forum: General Q & A
03-04-2010, 02:57 PM
Replies: 41
Views: 5,255
Posted By Kid Cumberland

30 or 32!!!??? Im currently running it at the...

30 or 32!!!??? Im currently running it at the stock 13 degrees. Please do educate me on this one!
Forum: General Q & A
03-01-2010, 01:04 PM
Replies: 41
Views: 5,255
Posted By Kid Cumberland

Id be interested in trying one out. Whats the...

Id be interested in trying one out. Whats the price?
Forum: General Q & A
03-01-2010, 12:59 PM
Replies: 41
Views: 5,255
Posted By Kid Cumberland

Im surprised this didn't come up earlier. Yes it...

Im surprised this didn't come up earlier. Yes it was 76mph on the GPS. Its a great running little boat. Im a pretty big fan of the 525SC but will give most of the credit to the hull design.
Forum: General Q & A
02-22-2010, 03:29 PM
Replies: 41
Views: 5,255
Posted By Kid Cumberland

How to get to 80 mph with a single screw

Hey All,
So I have a 95 27 Fountain Fever that I am trying to get another 4mph out of. Im running a stock 525SC setup and the boat tips out at 76MPH. Its seems to level off before the Chine Walkin...
Forum: Do It Yourself, Boating on a Budget
02-12-2010, 10:28 AM
Replies: 7
Views: 1,893
Posted By Kid Cumberland

Noticed your a pretty steady wealth of knowledge...

Noticed your a pretty steady wealth of knowledge around here so just curious why you changed yours out. Are youable to romove your valve covers with the lightning headers still on?
Forum: General Q & A
02-12-2010, 10:26 AM
Replies: 9
Views: 1,206
Posted By Kid Cumberland

I thought about Vinyl but was curious how that...

I thought about Vinyl but was curious how that lays over the current graphics as they are slightly raised.
Forum: General Q & A
02-11-2010, 02:57 PM
Replies: 9
Views: 1,089
Posted By Kid Cumberland

Just Called Holley and they gave me the old 10-12...

Just Called Holley and they gave me the old 10-12 torque number. So I guess I'll go with that. Now if I can just figure how to get a torque wrench in there.....
Forum: Do It Yourself, Boating on a Budget
02-11-2010, 02:27 PM
Replies: 7
Views: 1,893
Posted By Kid Cumberland

Headers for a 27 Fever 525SC??

Hey All,
I have a 95 27 foot fever with a single 525SC. Just finished my top end rebuild and am dreading putting the clunky oem exhaust manifiolds back on. Would really like some nice looking...
Showing results 1 to 25 of 38
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.