Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: macvtt
Showing results 1 to 25 of 47
Search took 0.00 seconds.
06-24-2005, 10:26 AM
Replies: 10
Views: 1,946
Posted By macvtt

Re: Charlotte County Florida

there are large boats in south gulf cove, one guy has a big orange outerlimits.
only way in or out is through a lock, (one of those gate type just to keep saltwater out).
biggest problem is the...
Forum: Spectre
06-02-2005, 01:20 PM
Replies: 6
Views: 1,463
Posted By macvtt

Re: 30 vs 36 pleasure deck ?

the 30 windscreen is a 36 windscreen, but it is cut down the middle and has a polished SS bracket in the middle... As long as it is the one from Spectre and not a aftermarket. The one in the pic of...
Forum: Spectre
05-25-2005, 11:43 AM
Replies: 5
Views: 1,320
Posted By macvtt

Re: Lifting eyes on a 30'

Call Jay..... He has always been extremely helpful... Best experience I have had with a boat.

Mike
05-24-2005, 07:58 AM
Replies: 39
Views: 4,408
Posted By macvtt

Re: Cabbage Key

Freeze Frame: 81mph ...that is fast for a 30ft outboard vee..

I would like to try that setup with a center console deck on that hull..

Thanks for the info,
Mike
05-23-2005, 04:51 PM
Replies: 39
Views: 4,408
Posted By macvtt

Re: Cabbage Key

Freeze Frame...
Was that your Super boat with the 225s ??

If so we where in the 30 Spectre parked in front..

How fast is the boat it looked cool.

By the way guys... Cabbage Key is a nice...
04-07-2005, 11:21 AM
Replies: 54
Views: 16,122
Posted By macvtt

Re: cobra cats

Special K....

I tried to respond to your message but you must have your private message turned off.
04-05-2005, 01:40 PM
Replies: 54
Views: 16,122
Posted By macvtt

Re: cobra cats

Skaterboy,

Thanks for the info!!!

I have also talked to Jim Richie who is as you said a great guy.
I also was able to get in touch with Peter , but still am in the same place. Our boat from...
03-28-2005, 12:27 PM
Replies: 2
Views: 649
Posted By macvtt

93 Octane fuel on the water Englewood, Venice area?

I need 93 Octane fuel for my 300x's . Are there any places on the water I can get it in the Englewood, Venice area?
Thanks guys.
10-21-2004, 03:28 PM
Replies: 6
Views: 922
Posted By macvtt

Where to get insurance for a tripple outboard cat???

We have a 36ft Cobra with 3 Yamaha 250s and need to get good insurance for it. (Blakadar is going out) The boat only runs about 75mph. Any ideas would be appreciated.

Thanks
06-03-2004, 10:26 AM
Replies: 8
Views: 1,098
Posted By macvtt

Re: Do I need to check anything after I lost by prop blade?

It is on a 30ft Spectre and I ran it for about a minute or two. Should I just put a straight edge on it. What about the seals?

Thanks alot guys.
06-01-2004, 05:33 PM
Replies: 8
Views: 1,098
Posted By macvtt

Do I need to check anything after I lost by prop blade?

As you guys know I threw a blade off my merc 3blade cleaver. Should I have anything checked out before I put the new one on and run it? Its a merc 300x with about 35 hours on it.

thanks
05-20-2004, 11:54 AM
Replies: 20
Views: 7,924
Posted By macvtt

Re: merc 3 blade cleaver broke

I would like to see the prop blade in the manatee club members head!!!! lol!!!
I am thinking about using non-lab props this time around. What do you guys think?
05-20-2004, 11:48 AM
05-18-2004, 08:04 AM
Replies: 59
Views: 11,625
Posted By macvtt

Re: BEST CAT from 30 to 35

With Blackadar going out of the high performance insurance biz, I think it might get really hard to get cat insurance at a reasonable cost.............and you can forget a cat with trips.
05-18-2004, 07:46 AM
Replies: 20
Views: 7,924
Posted By macvtt

Re: merc 3 blade cleaver broke

Speed: its a 03 30 Spectre with 300x and has about 35 hours on it.
Thanks for all the posts guys.
05-17-2004, 06:01 PM
Replies: 20
Views: 7,924
Posted By macvtt

merc 3 blade cleaver broke

Went out for a run today and broke a prop........I didnt hit anything......did I get a bad prop? Its a merc lab 3 blade cleaver 15x30.
05-09-2004, 07:39 PM
Replies: 26
Views: 6,011
Posted By macvtt

Have you looked at a 36 Spectre?

Have you looked at a 36 Spectre?
04-30-2004, 11:05 AM
Replies: 15
Views: 5,443
Posted By macvtt

Maximus, I also have a 30 Spectre with the...

Maximus,
I also have a 30 Spectre with the 300x. I have hydraulic CMC jackplates to raise the motors up while running. You are sure right on them being very sensitive. Water presure goes all at...
03-29-2004, 04:29 PM
Replies: 25
Views: 2,786
Posted By macvtt

Gail Banks just came out with one and it seems to...

Gail Banks just came out with one and it seems to be good. Some guys have problems with the edge when the trans shifts. go to www.fordtrucks.com under 6.0 and do a search. There are a few out now.
Forum: General Q & A
03-26-2004, 06:37 AM
Replies: 35
Views: 6,245
Posted By macvtt

when I flush with the MST the water also exits...

when I flush with the MST the water also exits out the drive.
03-09-2004, 11:04 AM
Replies: 13
Views: 6,165
Posted By macvtt

What about coastguard certification? When I was...

What about coastguard certification?
When I was looking at Motion they told me that they built it into the boat and said they needed the added strength built in for the boat. They also wanted to...
03-08-2004, 06:24 PM
Replies: 275
Views: 46,828
Posted By macvtt

04 f250 6.0 4x4 and 03 30ft Spectre 300x's

04 f250 6.0 4x4 and 03 30ft Spectre 300x's
01-27-2004, 10:22 AM
Replies: 37
Views: 33,032
Posted By macvtt

An AMT was in a recent boating magazine with the...

An AMT was in a recent boating magazine with the 300's. With the 300's watch the porpoising, the article said it did it almost all the time except at top speed which was about 100mph. I would...
01-19-2004, 05:06 PM
Replies: 17
Views: 4,128
Posted By macvtt

Go with the Spectre They are a great company to...

Go with the Spectre
They are a great company to deal with, build a fantastic product and Jay is extremly honest.
That new 24 kicks assss
11-26-2003, 05:00 PM
Replies: 7
Views: 1,021
Posted By macvtt

We have one for the 36 cobra center console. Only...

We have one for the 36 cobra center console. Only problem is where to mount the transducers. On the transom they disturb the water flow to the nosecone. We will be trying some other ideas. If it...
Showing results 1 to 25 of 47
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.