Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 11 of 15
« First
9
10
11
12
13
Last »
Search: Posts Made By: SeaWeasel
Showing results 251 to 275 of 364
Search took 0.01 seconds; generated 61 minute(s) ago.
Forum: Formula
08-13-2004, 12:18 PM
Replies: 3
Views: 756
Posted By SeaWeasel

Re: 311 Bolster Question

That is exactly what I need to do, too. Glad they come out without having to pull the whole bolster from the boat!.
Forum: Formula
08-13-2004, 11:16 AM
Replies: 3
Views: 756
Posted By SeaWeasel

311 Bolster Question

I need to remove the inside "legs", stanchions, uprights, whatever, from my bolsters. They have 2 #3 or 4 Phillips head screws on each "foot". Are these held in place by a threaded fitting, a nut...
Forum: Formula
08-13-2004, 11:10 AM
Replies: 31
Views: 5,037
Posted By SeaWeasel

Re: Need a tachometer

offthefront . . . that was me. All new bulbs- $60 worth at a discount -and no improvement. I will be swapping panel and quages out this winter. And while I am on the subject, who/where is the...
Forum: General Q & A
08-13-2004, 11:00 AM
Replies: 8
Views: 2,170
Posted By SeaWeasel

Stereo / Amp / Battery / Voltage Q?

I have a fairly straight-forward set up with a 6 channel amp running 2 pairs of components and a pair of 8ohm JBL 8's bridged to show the amp a 4ohm load mono on rear channels. I am running off a...
Forum: Formula
08-10-2004, 09:46 AM
Replies: 35
Views: 5,128
Posted By SeaWeasel

Re: 311 Props- What are you using???

offthefront- What pitch are those? I just bolted the 24's on and I think they work great with my power. The midrange goes off compared to what I had- my seat of the pants impression is that the...
Forum: Formula
08-09-2004, 12:52 PM
Replies: 35
Views: 5,128
Posted By SeaWeasel

Re: 311 Props- What are you using???

CMG, new they are about $600 each. Used $400-$600 a set. If you are looking I can pm you an address for a guy that has a pair for sale. And, not to steal Cuda's reply, but those are K&N's Flame...
Forum: Formula
08-09-2004, 09:49 AM
Replies: 1
Views: 727
Posted By SeaWeasel

311sr1 Head Compartment 2

I have noticed that the inner wall of my head compartment has started to shift around and has pulled the factory bracing out of the upper part of the headliner / underside of the deck. What is up...
Forum: Formula
08-09-2004, 09:45 AM
Replies: 0
Views: 887
Posted By SeaWeasel

311sr1 cockpit floor

I noticed I am getting some cracking in the forward portion of my center cockpit floor, right where the forward-most screws are located. You can actually hear a little "crackling" sound when you...
Forum: General Q & A
08-09-2004, 09:21 AM
Replies: 1
Views: 886
Posted By SeaWeasel

Rev Limiter Retrofit

I have a pair of '89 vintage 454's that have been toyed with so they are around 400hp. The builder replaced all of the ignition components with what amount to "stock" pieces- ie, they are...
Forum: Formula
08-08-2004, 07:26 PM
Replies: 35
Views: 5,128
Posted By SeaWeasel

Re: 311 Props- What are you using???

Quad IV's are the goods. Mid-range acceleration is great and the motors are not working nearly as hard. And jaybird, there is nothing wrong with fat girls . . . especially when they are fast!!! ...
Forum: Formula
08-05-2004, 11:12 AM
Replies: 35
Views: 5,128
Posted By SeaWeasel

Re: 311 Props- What are you using???

I have heard various stories about the 311's inability to go "fast" even with big power. My impression is that the boat is simply a big fat pig- which is one of the things that attracted me. I...
Forum: Formula
08-03-2004, 10:01 AM
Replies: 35
Views: 5,128
Posted By SeaWeasel

Re: 311 Props- What are you using???

Jaybird- I am only spinning to around 4500rpm right now- however, this is not WOT and not trimmed up. I have been gradually working my way up throttle to see where I get. Formula Outlaw- great...
Forum: Formula
08-02-2004, 03:48 PM
Replies: 23
Views: 4,039
Posted By SeaWeasel

Re: Head in 311sr

It was a wonderful experience- pulling into Glencove Yacht Club in my Uncle Eddie 311 sr 1 (trying not to scratch the multi-million dollar inventory of Sunseekers and new Formulas) and telling them...
Forum: Formula
08-02-2004, 02:20 PM
Replies: 35
Views: 5,128
Posted By SeaWeasel

311 Props- What are you using???

I know there is a way to start a poll . . . I would rather just ask: Anyone with a Bravo drive 311, what are you running for (a) power and (b) props and (c) what do you see for (i) hole shot (ii)...
Forum: Formula
07-27-2004, 07:32 AM
Replies: 23
Views: 4,039
Posted By SeaWeasel

Re: Head in 311sr

So, ah, how is it done? I assume there is no fitting or anything that you have to open or any of that? Just pull the "waste" cap off, stick the sucker hose in the waste-cap-hole and start pumpin'?...
Forum: Formula
07-26-2004, 11:12 AM
Replies: 2
Views: 1,105
Posted By SeaWeasel

311 Dash Panel

I need a source for a 311 dash panels for new gauges. Anyone done this? If so, any issues- i.e., sending units etc. backwards, blah blah? How about cost for panel and gauges? Pictures? Anyone? ...
Forum: Formula
07-26-2004, 10:59 AM
Replies: 23
Views: 4,039
Posted By SeaWeasel

Re: Head in 311sr

While we are on the subject . . . is there any magic to pumping that bad-boy out? "We" had to use it due to some unfortunate late evening drunken antics that put "us" in a position not to be able to...
Forum: Formula
07-13-2004, 04:50 PM
Replies: 15
Views: 5,885
Posted By SeaWeasel

Re: Gauge Bulb Reference

An update (as I know everyone has been waiting . . . hehhehehe . . not) on the bulb project. New bulbs did nothing for my gauges- still dim. I believe I will be getting the number for AutoMeter,...
Forum: Formula
06-21-2004, 07:20 AM
Replies: 15
Views: 5,885
Posted By SeaWeasel

Re: Gauge Bulb Reference

I put 10 new bulbs in yesterday . . . and should know next weekend whether I got anywhere. I believe the retail on the VDO bulbs is like $6.00 each . . . so, let me be the idiot guinea pig before...
Forum: Formula
06-15-2004, 08:07 PM
Replies: 15
Views: 5,885
Posted By SeaWeasel

Gauge Bulb Reference

There was a post on here at one time asking about replacement bulbs for the "red" lights in the gauge cluster of older Formulas that didn't manage to go anywhere. Has anyone got a part number or...
Forum: Formula
06-01-2004, 12:33 PM
Replies: 5
Views: 1,056
Posted By SeaWeasel

Hole in the dash . . .

I have an '89 sr-1 and I am going to install a Garmin 176c. I need to put 4 holes in the top af my dash to the outside of the compass. As easily as this wonderfully black gel-coat scratches, I was...
Forum: General Q & A
06-01-2004, 12:08 PM
Replies: 2
Views: 1,014
Posted By SeaWeasel

Voltage Regulator Regulation

I have an old 311 sr1 and the volt meters will show into the red (16 + volts) for periods of time and then go back to 13.8. I assume I have a voltage regulator problem with one or both alternators. ...
Forum: General Q & A
06-01-2004, 12:05 PM
Replies: 0
Views: 885
Posted By SeaWeasel

Water-spot remover

Drug the old 311 out of the H20 yesterday and sprayed it down with some water spot reomover. Left a little brownish-yellowish stain on the hull in a couple of spots. I washed it right off. Most of...
Forum: General Q & A
05-26-2004, 12:59 PM
Replies: 4
Views: 906
Posted By SeaWeasel

MO / LOTO H20 Patrol Question

I think this fits the "spirit" of this forum . . . My father has a cruiser that is USCG documented, and thus has no numbers. It is kept in Kansas, so he has no parks and wildlife sticker on it (not...
Forum: Formula
05-25-2004, 01:51 PM
Replies: 2,610
Views: 1,623,511
Posted By SeaWeasel

Re: Post pictures of your formula!!!

Awesome. You must either be an electronics freak or really do some serious navigation work!! Where are you doing your boating?
Showing results 251 to 275 of 364
 
Page 11 of 15
« First
9
10
11
12
13
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.