Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 3 of 20
1
2
3
4
5
13
Last »
Search: Posts Made By: Rik
Showing results 51 to 75 of 500
Search took 0.05 seconds; generated 61 minute(s) ago.
Forum: General Boating Discussion
08-16-2017, 11:15 AM
Replies: 37
Views: 9,821
Posted By Rik

With the area and the speed added to the desnity...

With the area and the speed added to the desnity of the water (and the amount of water) there is little that is going to protect the panels from breaking.

That being said, Aero Marine can make...
Forum: General Boating Discussion
08-01-2017, 09:17 PM
Replies: 48
Views: 10,334
Posted By Rik

We've got a solution that can fix your health...

We've got a solution that can fix your health problems. :)
Forum: General Boating Discussion
07-18-2017, 11:35 AM
Replies: 26
Views: 5,991
Posted By Rik

I didn't know I was so expensive.. Guess I need...

I didn't know I was so expensive.. Guess I need to start collecting more now. :)
Forum: Formula
07-02-2017, 01:13 AM
Replies: 14
Views: 7,228
Posted By Rik

First sea trial yesterday, ran it up to 88 mph...

First sea trial yesterday, ran it up to 88 mph with a lot of rpm and power left.

Bruce's comments " the acceleration will set you in your seat, it drives easier around the docks, it's awesome....
Forum: Drives and Lower Units
06-29-2017, 11:44 AM
Replies: 19
Views: 24,097
Posted By Rik

Buy whatever you wish but your pissing your $$...

Buy whatever you wish but your pissing your $$ away no matter what as the drives that are on the boat are good, even though they are 40 yrs old, they work and all is good.

You have to buy...
Forum: Formula
06-28-2017, 11:34 PM
Replies: 14
Views: 7,228
Posted By Rik

From what they have told me the engines are...

From what they have told me the engines are basically, on this particular boat, in the same place as they were before. The engine just have about 2-3 degrees upwards in the front.

Typically the...
Forum: Formula
06-28-2017, 11:40 AM
Replies: 14
Views: 7,228
Posted By Rik

Another Formula 382 getting the Arneson Upgraded Drives. #7M Kits

Here's another Formula 382 with the Arneson #7M Kits. The boat has a pair of 540's naturally aspirated built by ATECO engines..

Should be in the water this week for a sea trial.
Forum: General Boating Discussion
06-27-2017, 01:26 PM
Replies: 10
Views: 2,418
Posted By Rik

As Chris noted the CV's were used back in the...

As Chris noted the CV's were used back in the late 70's and some of the 1600's had UJ's instead. Which one?? Can't see from the outside so there's no physically so it's pot luck.

CV company that...
Forum: General Boating Discussion
06-23-2017, 12:11 PM
Replies: 10
Views: 2,418
Posted By Rik

I've told you this before. Mark the input...

I've told you this before.

Mark the input shaft at 12 o'clock
Mark the prop shaft at 12 o'clock
Turn the input shaft ONE time..
See where the prop shaft is.

9 O'clock is a 1.32
7:30 is a...
Forum: Drives and Lower Units
06-12-2017, 06:31 PM
Replies: 4
Views: 1,680
Posted By Rik

8500 lbs. I'd bet closer to 10,500 lbs. Need...

8500 lbs. I'd bet closer to 10,500 lbs.

Need gear ratio
Forum: Drives and Lower Units
06-06-2017, 07:28 PM
Replies: 33
Views: 14,594
Posted By Rik

I attempted.. He hasn't given a lot of...

I attempted.. He hasn't given a lot of information however.
Forum: Drives and Lower Units
06-06-2017, 07:27 PM
Replies: 4
Views: 1,680
Posted By Rik

What Quinlan said. The 1600's were rated at...

What Quinlan said.

The 1600's were rated at 1,000 hp and required a counter rotating engine. Some were converted to a counter rotating drive by people. Some good some so so.
Propellers... I...
Forum: Drives and Lower Units
06-06-2017, 11:04 AM
Replies: 33
Views: 14,594
Posted By Rik

We've got Chris Cat's with the Arnesons on them...

We've got Chris Cat's with the Arnesons on them too. Never to soon to start the project
Forum: Drives and Lower Units
06-05-2017, 07:27 PM
Replies: 33
Views: 14,594
Posted By Rik

Mario Genovese bought that boat.. Jeff's is from...

Mario Genovese bought that boat.. Jeff's is from the West Coast
Forum: Drives and Lower Units
05-10-2017, 11:13 AM
Replies: 60
Views: 22,374
Posted By Rik

You need a 1/2" I.D. hose to feed the pump from...

You need a 1/2" I.D. hose to feed the pump from the reservoir. No hard 90's between the pump and the reservoir, and the reservoir has to be higher than the pump.. The pump cannot suck... It just...
Forum: Drives and Lower Units
05-09-2017, 12:11 PM
Replies: 60
Views: 22,374
Posted By Rik

1 gallon because he has two pumps pumping 4gpm...

1 gallon because he has two pumps pumping 4gpm each.. That means a 1 gallon reservoir is being turned over volume wise once every 7.5 seconds..

The oil needs time to come in and get back out as...
Forum: General Boating Discussion
04-28-2017, 10:55 AM
Replies: 63
Views: 12,414
Posted By Rik

[email protected] 415-485-0788

[email protected]

415-485-0788
Forum: General Boating Discussion
04-26-2017, 07:09 PM
Replies: 63
Views: 12,414
Posted By Rik

Are you sure that we cannot help you with your...

Are you sure that we cannot help you with your project? We're faster, more reliable and probably not much more $$
Forum: General Boating Discussion
04-22-2017, 05:36 PM
Replies: 63
Views: 12,414
Posted By Rik

The problem isn't the Bravo, nor is it Mercury. ...

The problem isn't the Bravo, nor is it Mercury.

The problem is with the boaters. They want and believe that if it's not a Bravo then it's not right. They want their outdrives cheap, and they...
Forum: General Boating Discussion
04-19-2017, 10:08 AM
Replies: 15
Views: 3,460
Posted By Rik

This is the exact scenario why we make a...

This is the exact scenario why we make a propeller guard. This prevents one from being able to fall onto the propeller.

Also we are only 4" longer than the setup of your Bravo on a stand off...
Forum: Drives and Lower Units
04-18-2017, 01:07 PM
Replies: 7
Views: 1,721
Posted By Rik

They were just threaded S.S. rod I believe. Not...

They were just threaded S.S. rod I believe. Not hard to make

Grade 8 will rust away over time.
Forum: General Boating Discussion
04-14-2017, 11:10 PM
Replies: 15
Views: 3,460
Posted By Rik

Here's what fun looks like with only 800 hp...

Here's what fun looks like with only 800 hp Teague. Boat can reach 107.

https://youtu.be/gjgCvTsRkyU
Forum: General Boating Discussion
04-13-2017, 10:55 AM
Replies: 15
Views: 3,460
Posted By Rik

With your power and hull, have you considered an...

With your power and hull, have you considered an Arneson?
Forum: Drives and Lower Units
03-23-2017, 11:17 AM
Replies: 7
Views: 1,721
Posted By Rik

Ok..... .. .. .. . Your 1720 has a 6 or...

Ok..... .. .. .. .


Your 1720 has a 6 or 7 degree angle cast into it. Your mounting surface of the transom where the socket housing is to be mounted needs to be roughly 12-13 degrees in order...
Forum: Skater
03-07-2017, 05:22 PM
Replies: 1,124
Views: 336,517
Posted By Rik

This one is in the paint booth 565406 This...

This one is in the paint booth
565406

This one is next to get a deck
565407
Showing results 51 to 75 of 500
 
Page 3 of 20
1
2
3
4
5
13
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.