Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: wuzzgunna
Showing results 1 to 15 of 15
Search took 0.00 seconds; generated 79 minute(s) ago.
Forum: Electronics
03-14-2022, 12:36 PM
Replies: 3
Views: 1,180
Posted By wuzzgunna

Auto meter gps speedo

can I get reasonably gps signal if I mount the gps antenna for my auto meter speedo under the dash. Does the antenna really need to be mounted on the top side for a clear view to the satellites....
Forum: General Q & A
07-05-2021, 07:29 PM
Replies: 7
Views: 992
Posted By wuzzgunna

Ya but? BBC parts from what generation. If you...

Ya but? BBC parts from what generation. If you look at generic Chevy car parts, are they before 1972, short shaft corvette pumps, standard 72-1991 gen part. There are approximately. 10 different...
Forum: General Q & A
07-04-2021, 09:08 PM
Replies: 7
Views: 992
Posted By wuzzgunna

gen 6 502 mpi aluminum water pumps

lost a seal in my bone stock--engine mounted water pump today. anyone ever run an aftermarket aluminum water pump. I ran an Edelbrock one on my small block for yrs. In lake michigan, corrosion is...
Forum: Drives and Lower Units
05-31-2021, 09:13 AM
Replies: 5
Views: 904
Posted By wuzzgunna

bravo mount bolts

is there a better place than mercury to buy 7/16 x 20 nylock mount nuts to bolt up bravo drives. Merc. gets a really health (expensive) price for them i believe. If changing out one or 2 ok, but I...
Forum: Trucks, Trailers and Transportation
12-06-2020, 07:25 PM
Replies: 15
Views: 6,140
Posted By wuzzgunna

wheel bearing grease?

I have been dilengently using water proof "sta lube grease" for many years. Boating in west michigan "freash water" all the time. Last yr I replaced all the bearing with american made "timkins"...
Forum: Great Lakes and Canada
07-14-2020, 07:14 PM
Replies: 10
Views: 3,143
Posted By wuzzgunna

been using Dutton park in holland. ramps ok and...

been using Dutton park in holland. ramps ok and there is parking for bigger rigs. I'm only 34 ft so not bad. couple of weeks back, tried port sheldon? won't do that again. none of the parking...
Forum: General Q & A
07-03-2020, 08:35 AM
Replies: 4
Views: 1,378
Posted By wuzzgunna

Mine vapor locked last weekend. No fuel press. ...

Mine vapor locked last weekend. No fuel press. Crank and bleed. WOT and it finally came to life. First time for me.
Forum: Great Lakes and Canada
04-12-2020, 08:06 PM
Replies: 10
Views: 3,143
Posted By wuzzgunna

hey 1960 brookwood, does port sheldon have any...

hey 1960 brookwood, does port sheldon have any restrictions on triple axle trailers there? cant remember myself.
Forum: Do It Yourself, Boating on a Budget
01-01-2019, 02:30 PM
Replies: 3
Views: 921
Posted By wuzzgunna

I'll give them a try thanks

I'll give them a try thanks
Forum: Do It Yourself, Boating on a Budget
12-28-2018, 09:39 AM
Replies: 3
Views: 921
Posted By wuzzgunna

Silent choice cutout solenoids

Good morning everyone, happy almost 2019 new years. i’m looking to replace some old and falling apart silent choice electric cutout solenoid boots. The one that cover the actuator rods on the...
Forum: Insurance and Finance
10-23-2018, 07:44 PM
Replies: 16
Views: 5,280
Posted By wuzzgunna

I was just *****ing to my agent here in west...

I was just *****ing to my agent here in west michigan yesterday. My 98 powerquest vyper just went from $626 to $840 annually..
40,000 boat and 10,000 trailer he was saying that the comprehensive...
Forum: Do It Yourself, Boating on a Budget
02-25-2018, 07:56 PM
Replies: 0
Views: 717
Posted By wuzzgunna

502 mpi mag thread size

Was putting things back together on my 502 mpi mag port eng. yesterday. I found the power steering pressure hose cracked right at the point where the hose crimps to the fitting off the back side of...
Forum: Do It Yourself, Boating on a Budget
02-11-2018, 05:22 PM
Replies: 3
Views: 1,369
Posted By wuzzgunna

spark plug wires

I went to change out my spark plugs wires my 502 mpi mags over this weekend. I found that I had ordered the wrong sets of accel 8.8 ready make wire kits part #8848. These turned out to be for small...
Forum: Do It Yourself, Boating on a Budget
01-30-2018, 07:46 PM
Replies: 5
Views: 1,903
Posted By wuzzgunna

Cool, will bolt the covers back down. Thanks

Cool, will bolt the covers back down.
Thanks
Forum: Do It Yourself, Boating on a Budget
01-29-2018, 08:55 PM
Replies: 5
Views: 1,903
Posted By wuzzgunna

502 mpi mag vavle springs

Hey, This is my first post on the forum. I've been reading back through some old posting trying to find any info on replacement valve springs for the 502 mpi mag from 1997. Just bought a Powerquest...
Showing results 1 to 15 of 15


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.