Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: Carlo
Showing results 1 to 25 of 35
Search took 0.00 seconds; generated 37 minute(s) ago.
Forum: Drives and Lower Units
07-08-2017, 06:03 AM
Replies: 2
Views: 1,243
Posted By Carlo

TRS parts wanted.

Looking to buy new Bearing Carrier Mercruiser Part No. 66663A1. LH Prop Shaft Mercruiser Part No.44-92327.
Needs to be shipped to the UK.
Forum: Cigarette
05-18-2015, 08:37 AM
Replies: 4
Views: 686
Posted By Carlo

Thanks for that i'll see what I can find. Carlo

Thanks for that i'll see what I can find. Carlo
Forum: Cigarette
05-18-2015, 08:36 AM
Replies: 4
Views: 686
Posted By Carlo

Many thanks i'll get looking. Carlo

Many thanks i'll get looking. Carlo
Forum: Cigarette
05-17-2015, 03:54 PM
Replies: 4
Views: 686
Posted By Carlo

Oil Temp Sender

Hi, where will I find the oil temp sender on Mercruiser 425 HP (OD763965) fitted in 93 Cafe Racer in the UK.

Regards, Carlo.
Forum: Cigarette
05-07-2012, 02:47 PM
Replies: 2
Views: 844
Posted By Carlo

Hi, I am in the UK with a Cafe Racer. Not sure...

Hi, I am in the UK with a Cafe Racer. Not sure what a "msd" set up is? Had to fit a replacement Merc rev limiter to the sbd engine last September and am waiting for one to be shipped at the moment...
Forum: Do It Yourself, Boating on a Budget
05-07-2012, 02:22 AM
Replies: 0
Views: 677
Posted By Carlo

Rev Limiter

Is it possible to bypass or wire out the Rev Limiter/Overspeed Assembly on Mercruiser 425 HP's with Thunderbolt IV ignition ?
Forum: Cigarette
05-07-2012, 02:15 AM
Replies: 2
Views: 844
Posted By Carlo

Rev Limiter

Is it possible to bypass or wire out the rev limiter/overspeed assembly on Mercruiser 425 HP's with Thunderbolt IV ignition ?
Forum: Cigarette
01-30-2012, 10:02 AM
Replies: 3
Views: 827
Posted By Carlo

TRS Ram pipe thread sizes.

Hi, its the standard cable and hydraulic ram system where the movement on the outer cable operates the control valve.
Its on a 93 build Cafe Racer.
I think it is 7/16" but I dont know what type of...
Forum: Cigarette
01-29-2012, 03:18 PM
Replies: 3
Views: 827
Posted By Carlo

TRS Steering Ram thread size.

Having to modify existing TRS power steering. Does anyone know the thead size of the 2 pipe fittings in the steering ram?
Forum: Cigarette
01-06-2012, 08:22 AM
Replies: 9
Views: 2,417
Posted By Carlo

TRS alignment.

Hi, ok I see what you mean now thanks to the pics from my friend "seafordguy". They want about $200 for the tool here in the UK ! so if I could get the dimensions I can get it machined up for a lot...
Forum: Cigarette
01-05-2012, 04:26 PM
Replies: 9
Views: 2,417
Posted By Carlo

Hi, am a little confused by your question of...

Hi, am a little confused by your question of "offshore mounts" ?
Forum: Cigarette
01-05-2012, 03:13 PM
Replies: 9
Views: 2,417
Posted By Carlo

TRS alignment tool.

Hi, would anyone have the dimensions/drawing for the TRS alignment tool. I have a pair of 425's in a 93 Cafe with Borg Warner boxes.
Forum: Cigarette
09-05-2011, 12:34 PM
Replies: 3
Views: 1,188
Posted By Carlo

Problem Solved

Thanks for your suggestions. Discovered that the culprit is the rev limiter (Overspeed Assembly) - the little black box that hides behind the module marked Thunderbolt IV. Managed to find a new one...
Forum: Cigarette
09-03-2011, 01:34 PM
Replies: 3
Views: 1,188
Posted By Carlo

Engine still won't fire up.

Further to my thread "Ignition Problem", thought we had found the problem and replaced the ignition sensor but still no luck! The coil,distributor cap and amplifier are all ok, the only odd thing is...
Forum: Cigarette
09-01-2011, 03:35 PM
Replies: 3
Views: 739
Posted By Carlo

Found the problem

Hi, thanks for your suggestion. Did a test on the ignition sensor and it was completely "dead". Picking up a replacement tomorrow. Genuine merc part about $200 here in the UK!! you guys don't know...
Forum: Cigarette
08-30-2011, 02:28 PM
Replies: 3
Views: 739
Posted By Carlo

Ignition Problem

Have a pair of 425's in 93 Cafe Racer. Starboard engine recently been playing up when trying to start but would eventually run smoothly but when switched off would not want to start again. Removed ...
Forum: Cigarette
08-12-2011, 02:31 AM
Replies: 7
Views: 1,136
Posted By Carlo

Hi, you must be joking! You have obviously not...

Hi, you must be joking! You have obviously not experienced a day on the beach in the UK. I would rather stick pins in my eyes!

Carlo.
Forum: Cigarette
08-12-2011, 02:26 AM
Replies: 7
Views: 1,136
Posted By Carlo

Operating Instructions.

HI Eric

Thanks for the info and the diagram. Still unsure why there is a inlet/outlet fitiing on the side deck marked "waste" - is this for use in a Marina where they have a pump out facility?...
Forum: Cigarette
08-11-2011, 12:53 PM
Replies: 7
Views: 1,136
Posted By Carlo

Operating Instructions for "Head" in 93 Cafe Racer

The head has two buttons under the bowl. One is marked "press to flush" the other has no marking. On the deck there is a fitting marked "waste". If the inlet and outlet valves are open do you just...
Forum: General Q & A
05-28-2010, 01:45 AM
Replies: 8
Views: 861
Posted By Carlo

Holley, I think 4150. I have not checked the...

Holley, I think 4150. I have not checked the filters on the feed into the carb itself - do you think this could be a possible ?
Forum: General Q & A
05-27-2010, 03:59 PM
Replies: 8
Views: 861
Posted By Carlo

Fuel Problem ?

Have a pair of 425 Mercruisers in a Cafe Racer in the UK.
Having a problem with one engine, it will not run without having to keep pumping the throttle lever and will only reach about 3000rpm under...
Forum: General Q & A
11-13-2008, 11:04 AM
Replies: 1
Views: 699
Posted By Carlo

Question Replace or repair fuel pump.

Have a pair of 425's (93 build) in a Cafe Racer here in the UK.
The fuel pumps are fitted to the Raw Water pumps. Is it possible to purchase a repair kit which includes replacement diaphragms? If...
Forum: Cigarette
07-20-2008, 02:23 PM
Replies: 2
Views: 8,794
Posted By Carlo

Change from 120v to 240v on Cafe Racer

Many thanks for the info. At the moment I use a transformer I had specially built but it weighs a ton!! I am also going to replace the battery charger as I am only getting 11.4 volts. The replacement...
Forum: Cigarette
07-20-2008, 03:01 AM
Replies: 2
Views: 8,794
Posted By Carlo

Question Wiring Diagram

Does anyone have the 120v wiring circuit for a 93/94 Cafe Racer. I would like to change to 240v input here in the UK.
Forum: Cigarette
07-10-2008, 02:53 PM
Replies: 0
Views: 2,252
Posted By Carlo

Question Replace Steering Cable

OK guys it must be the cable!
Any advice and information on how I get at the rack behind the wheel to replace the steering cable on a 94 Cafe would be a great help here in the UK. I can see that...
Showing results 1 to 25 of 35
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.