Holley Snipper
#51
Registered
Update, lake level finally came down, ran the boat today for 3 hrs with no problems from the Holley sniper EFI, AFR's stayed as set seem ok at this time,
Regards
Regards
Last edited by Texascuda; 06-29-2019 at 08:31 PM.
#53
Platinum Member
Platinum Member
iTrader: (6)
Very nice ^^^^^ coil on plug also, you'll like it after the bugs are worked out
Last edited by F-2 Speedy; 06-30-2019 at 10:18 AM.
#55
Registered
iTrader: (1)
I finally made it out for a few hours on the new engine and I can’t say that I miss playing with jets one bit. Set some parameters, run across the lake a few times, and done.
13.5 for idle.
12.8 for cruise.
12.5 wot.
I’m having an issue with getting the IAC below 20%, but a few minutes on the internetz oughta sort that out.
13.5 for idle.
12.8 for cruise.
12.5 wot.
I’m having an issue with getting the IAC below 20%, but a few minutes on the internetz oughta sort that out.
#56
Registered
Join Date: Jul 2016
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
I finally made it out for a few hours on the new engine and I can’t say that I miss playing with jets one bit. Set some parameters, run across the lake a few times, and done.
13.5 for idle.
12.8 for cruise.
12.5 wot.
I’m having an issue with getting the IAC below 20%, but a few minutes on the internetz oughta sort that out.
13.5 for idle.
12.8 for cruise.
12.5 wot.
I’m having an issue with getting the IAC below 20%, but a few minutes on the internetz oughta sort that out.
Hoping to get this conversion done soon on my 454 mag, running sniper and a surge tank/pump combo.
FYI - I've had good luck with holley responding to all my technical questions, even before anything was ever purchased.
#57
Registered
Update: As of today 10 hrs on the motor runs fine the Sniper is working and and the added pipe inside the riser, seems to be keeping the 02 dry. Ran 63 on gps with 5 people and 70 gals of gas.