Question for fellow Sonic Boaters
#1
Registered
Thread Starter
Join Date: Apr 2006
Location: Concord, NH
Posts: 54
Likes: 0
Received 0 Likes
on
0 Posts
Question for fellow Sonic Boaters
Hi,
Put the 358 in for the first time yesterday. We were very pleased to say the least!
Can anyone weigh in on why the port trim tab indicator stopped working but the trim tab itself is working????
This is an '02 358 w/ twin 500's.
TY
Mike
Put the 358 in for the first time yesterday. We were very pleased to say the least!
Can anyone weigh in on why the port trim tab indicator stopped working but the trim tab itself is working????
This is an '02 358 w/ twin 500's.
TY
Mike
#4
Registered
Join Date: Jun 2001
Location: Lehigh Valley, Pennsylvania
Posts: 1,567
Likes: 0
Received 0 Likes
on
0 Posts
I'm currently working on the cables for the drives on my 31, however the tab cables are the same. Being that you are in the water will make this difficult, any way of pulling it out for a short period? If you disconnect both ends, you should be able to push and pull the cable by hand to see what might be causing the problem. Actually, just disconnect the cable at the trim tab and push pull the cable, should be only about 4" - 6" length you can pull in or out. If it's not working, either end would have to have come disconnected or the cable snapped inside the sheathing which would allow you to pull the cable all the way out. Once you have the one end off, you should find out right away what the problem is. Good luck!!!!
Thread
Thread Starter
Forum
Replies
Last Post
THRILLSEEKER
General Boating Discussion
12
09-12-2003 07:35 AM