New 2009 32' Spectre Completed
#41
Thanks for all the good comments.
Saturday we went to the lake and met Mark and Bev. They drove down from Tennessee too look at the boat. We went do some running around and crossed the lake and went to the north shore and had some lunch. We also did some testing when we crossed the lake. We had better then 3/4 of fuel in each tank (65 gal. each) and five people and all the gear for the day.
Here is some info. Running 15X32 three blade non-lab Mercury cleaver.
3000 RPM - 34 MPH - Fuel- 7.3 gal. per Hr. each motor
4000 RPM - 56 MPH - Fuel- 9.5 gal. per Hr. each motor
5000 RPM - 80 MPH - Fuel- 14.3 gal. per Hr. each motor
6000 RPM - 96 MPH - Fuel- 22 gal. per Hr. each motor
WOT 6300 RPM - 100 MPH on the rev-limiter did not look at the fuel.
All MPH was verified by Three GPS on board.
Saturday we went to the lake and met Mark and Bev. They drove down from Tennessee too look at the boat. We went do some running around and crossed the lake and went to the north shore and had some lunch. We also did some testing when we crossed the lake. We had better then 3/4 of fuel in each tank (65 gal. each) and five people and all the gear for the day.
Here is some info. Running 15X32 three blade non-lab Mercury cleaver.
3000 RPM - 34 MPH - Fuel- 7.3 gal. per Hr. each motor
4000 RPM - 56 MPH - Fuel- 9.5 gal. per Hr. each motor
5000 RPM - 80 MPH - Fuel- 14.3 gal. per Hr. each motor
6000 RPM - 96 MPH - Fuel- 22 gal. per Hr. each motor
WOT 6300 RPM - 100 MPH on the rev-limiter did not look at the fuel.
All MPH was verified by Three GPS on board.

#42
Thread Starter
Registered

Joined: May 2007
Posts: 100
Likes: 0
From: New Orleans, LA
[Thanks for the compliment. I appreciate it. I think next Summer I'll get a set of 4 blades and give them a spin. 
Here is a Pic at crab Island.

Here is a Pic at crab Island.
Last edited by TB Racing; 08-27-2009 at 07:39 PM.
#47
Thread Starter
Registered

Joined: May 2007
Posts: 100
Likes: 0
From: New Orleans, LA
Thanks for the compliment on the boat. I sent the props to Brett at BBlades friday to have them worked up to get off the rev limiters and get more speed.
Last edited by TB Racing; 01-17-2010 at 11:16 AM.
#49




