20ft super pacer
09-19-2007 | 08:01 PM
#2
Registered
Joined: Mar 2001
Posts: 1,239
Likes: 113
From: Oakville,ON
With a Bravo on a 20 you will likely run out of transom before you get too high. The top of my drive was at the top of the hull and the hull along with the rub rail was cut to allow the drive to sit flush. You may want to check with the factory to see if a shorty drive might be the best answer.
Post some pics of this project!
Post some pics of this project!
09-22-2007 | 09:12 PM
#3
Platinum Member
Joined: May 2003
Posts: 695
Likes: 44
From: Finger Lakes region, NY
x dim
The last 20' built (sold a few months ago up in NJ) has a Bravo 1 with an MX6.2. Richie Jr. had to cut the sun pad and add some height so the engine would fit with proper x dimension. The new 21 hull and deck have added free board so a bravo drive will fit with a flat sun pad.
09-22-2007 | 09:12 PM
#4
Platinum Member
Joined: May 2003
Posts: 695
Likes: 44
From: Finger Lakes region, NY
x dim
The last 20' built (sold a few months ago up in NJ) has a Bravo 1 with an MX6.2. Richie Jr. had to cut the sun pad and add some height so the engine would fit with proper x dimension. The new 21' hull and deck have added free board so a bravo drive will fit with a flat sun pad.
Last edited by Ing; 09-22-2007 at 09:24 PM.
