Winch stand....
06-27-2008 | 06:23 PM
#21
Rob
Joined: Aug 2001
Posts: 21,637
Likes: 12
From: Ms
06-28-2008 | 12:35 PM
#23
Rob
Joined: Aug 2001
Posts: 21,637
Likes: 12
From: Ms
06-29-2008 | 09:46 AM
#24
Charter Member #927
Joined: Jan 2001
Posts: 4,834
Likes: 2
From: IN
Nice job Roger. That gives me some ideas for improvments for my Myco. My boat doen't hit the winch, but on a steep ramp I have keep winching to slide my hull up the front blocks a few inches or else when I pull out and am on flat ground the bow will be a few inches from the bow stop.
06-29-2008 | 02:34 PM
#25
Registered
Joined: Dec 2002
Posts: 3,705
Likes: 0
From: Kankakee Illinois
Nice job Roger. That gives me some ideas for improvments for my Myco. My boat doen't hit the winch, but on a steep ramp I have keep winching to slide my hull up the front blocks a few inches or else when I pull out and am on flat ground the bow will be a few inches from the bow stop.
Thanks Mark;
That's why I extended it out there like I did. I did'nt want Mark to have problems with it on the ramp and me down here in kankakee wondering why my ears felt like they were on fire....................
07-02-2008 | 05:50 AM
#26
Registered
Joined: May 2005
Posts: 393
Likes: 0
From: Tampa, Florida
I made one very similar to yours and it works awesome, except: The wind cought the boat right before it was going in the bow stop and that metal edge gave me a reminder in my boat. I am now working on a protector on the outside of the metal just in case it should happend again. I will also add some side support (towards the rear of the boat and middle of boat) for easier docking when I am by myself. As soon as I have it painted I will post some pictures...
Thread
Thread Starter
Forum
Replies
Last Post
handfulz28
Trucks, Trailers and Transportation
5
02-26-2008 11:48 AM
