Mods
02-03-2004 | 09:34 PM
#22
Registered
Joined: Sep 2002
Posts: 604
Likes: 0
From: Charlotte, nc.
Re: Velocity Mark
Originally posted by Linster
Here's how I did mine. I used 1/4" Aluminum diamond plating. When I was looking around I could have gotten 1/16 Stainless Steel Diamond plating that was a little more expensive. I wish I would have done it now because the Aluminum takes some hand rubbing to keep it looking good. I used cardboard to make the template to cut the aluminum. Your engine looked great!
Linnie
Here's how I did mine. I used 1/4" Aluminum diamond plating. When I was looking around I could have gotten 1/16 Stainless Steel Diamond plating that was a little more expensive. I wish I would have done it now because the Aluminum takes some hand rubbing to keep it looking good. I used cardboard to make the template to cut the aluminum. Your engine looked great!
Linnie
