Think I have the water pump in figured out. Not pretty for the time being but until I find a decent SS street elbow the galvanized will have to do. The galvanized elbow does fit just about perfectly though
[ATTACH=CONFIG]567339[/ATTACH]

[ATTACH=CONFIG]567337[/ATTACH]

Sea strainer will go somewhere in this area. Need diamond plate pieces before I make mount the strainer though
[ATTACH=CONFIG]567338[/ATTACH]

We're getting closer

What gear case are you going with?

1300 scx. 2.25" below bottom on 12" box

Nice good luck with it, looking forward to seeing the results of your hard work.

Thanks pro27. I've admired your setup for awhile now. Didn't plan on going with this much motor but one happened to be for sale when I was looking. I wish I could've gone with the scx-4 but then I probably would have to redo the transom to get it high enough.

Dash panel done. Going to run the Simrad only with the smartcraft and see how I like it. If I feel I need some analog gauges I can add them.

[ATTACH=CONFIG]567399[/ATTACH]

[ATTACH=CONFIG]567400[/ATTACH]

[ATTACH=CONFIG]567401[/ATTACH]

Had to cover the back of the glove box and overlap where the front wraps around. Easy to see it's vinyl but it'll do for now at least.
[ATTACH=CONFIG]567402[/ATTACH]

[ATTACH=CONFIG]567403[/ATTACH]

When I wrapped my glove box, I just cut the edge so you couldn't see it when opened. White carbon fiber..
looks good!

[ATTACH=CONFIG]567414[/ATTACH]

And cut out a Baja logo on wifes machine!

On the Cricut? They are awesome

[ATTACH=CONFIG]567422[/ATTACH]
The blue is actually the exact same graphic on the back of the boat pulled off a picture. I think I use that vinyl cutter more than her

Do you have a picture of the back of your glove box?

Her machine is Silouette cutter. I do not have a pic of back,,, its not covered in vinyl, just plain stock white. There is no overlap. Since your vinyl is dark, paint the edge dark to match vinyl and just trim the vinyl on the top edge with a razor. Yours looks good too! Who opens it anyway!

Wow very nice