Lighting jacks is doing a killer job on the glass work.
[ATTACH=CONFIG]517603[/ATTACH]
[ATTACH=CONFIG]517604[/ATTACH]

Looks awesome some good hard work and long hours in this boat.

Going to be stronger than ever. Great job!

[ATTACH=CONFIG]517942[/ATTACH] filling all the holes. Notice the snow on the ground! Yeah south louisiana

Can see the notch too in this pic.

why did you take the tanks out if they were still good? just for a big clean up while at it?

To start how do you know what the bottom side of them look like? What looks ok on the top can be all pitted on the bottom and sides and about to go. The foam was old and pulled away in parts so wile it was a part way not? Had new foam for it to repair it so desided to make it right and go 100% into it. Then from there beefed up parts of the boat bullets are known to be week. Like the back bulk head.while there beefed up the front one as well. Then reworked some other things like the drains for the front and cockpit. It's dumb and expensive some say, but I know what I have and it's right and not going to give me problems.

You can spend thousands on pain and bling and still have a pice of crap under it. What we call a lip stick boat looks good but is junk. My not have bling but will be built right and like a tank.

nice to see it progressing along...may is not too far off. You gonna make it?

[ATTACH=CONFIG]518186[/ATTACH]
Ready for paint

[ATTACH=CONFIG]518187[/ATTACH]
New coosa bulge pump mounts

[ATTACH=CONFIG]518199[/ATTACH]
While doing glass and all speaker boxs in the gunnels

Niiiiice work. I get more jealous every time I look.