Bullet rebuild
02-12-2014 | 11:19 AM
#82
Thread Starter
VP of the tickfaw200
Joined: Jul 2007
Posts: 2,124
Likes: 184
From: baton rouge, louisiana
Made the inter transom plates so had to block off the exhaust on the gembles too
Front hole
[ATTACH=CONFIG]518475[/ATTACH]
[ATTACH=CONFIG]518477[/ATTACH]
Bottom holes
[ATTACH=CONFIG]518478[/ATTACH]
[ATTACH=CONFIG]518479[/ATTACH]
Front hole
[ATTACH=CONFIG]518475[/ATTACH]
[ATTACH=CONFIG]518477[/ATTACH]
Bottom holes
[ATTACH=CONFIG]518478[/ATTACH]
[ATTACH=CONFIG]518479[/ATTACH]
Last edited by caseyh; 02-12-2014 at 11:41 AM.
02-12-2014 | 04:45 PM
#84
Thread Starter
VP of the tickfaw200
Joined: Jul 2007
Posts: 2,124
Likes: 184
From: baton rouge, louisiana
I'll let you know next time John. Should be going over there shortly with in the next week or so.
Back of gemble hole. Was way easer then I expected to weld being cast.
[ATTACH=CONFIG]518502[/ATTACH]
Back of gemble hole. Was way easer then I expected to weld being cast.
[ATTACH=CONFIG]518502[/ATTACH]
03-21-2014 | 09:22 AM
#87
Thread Starter
VP of the tickfaw200
Joined: Jul 2007
Posts: 2,124
Likes: 184
From: baton rouge, louisiana
Sprayed imron on the gembles came out great. Laid down flat and shinty. The old TRS stuff is not perfect so the ruff shows but looks good.[ATTACH=CONFIG]520690[/ATTACH]
03-25-2014 | 09:41 AM
#88
Thread Starter
VP of the tickfaw200
Joined: Jul 2007
Posts: 2,124
Likes: 184
From: baton rouge, louisiana
[ATTACH=CONFIG]520893[/ATTACH]
Gel coated should get imron this week!
[ATTACH=CONFIG]520894[/ATTACH]
[ATTACH=CONFIG]520895[/ATTACH]
[ATTACH=CONFIG]520896[/ATTACH]
Gel coated should get imron this week!
[ATTACH=CONFIG]520894[/ATTACH]
[ATTACH=CONFIG]520895[/ATTACH]
[ATTACH=CONFIG]520896[/ATTACH]
03-26-2014 | 11:13 AM
#90
Registered
Joined: Jun 2009
Posts: 339
Likes: 0
From: League City, Tx
