Couple questions, are you guys tapping into your existing bilge light to turn on and off and what are you using to mount them? Double sided tape wouldn't cut would it?

Its such a general question. Theres a ton of LED products and companies its like asking which bread should I eat. Just pick the one you like and go with it..
But since the question was asked I cant miss an opportunity to post a pic










$22 for 16' waterproof roll ...can`t go wrong

Yes and yes... 3M 150' roll at home depot $15

I'm going to set them up on their own switches.. just not sure that I can justify the $ for the stingerz. May go with the ledglow..looks like a nice set up for the $

I used ledglow on mine. They are remote controlled & can be hooked into the stereo also. These pics are blurry cause the camera wouldnt focus right but show how much they light up. I have six more small tubes I can mount but havent done it yet. Randy

You have the color changing?

You can change color, dim, run chase patterns and hook to stereo all remote controlled with a keyfob. The kit is also expandable. www.LEDGLOW.com entire kit about 175.00 Randy

I had a spare accessory switch in my dash so when I had the interior out I just ran wiring direct up to the switch in the dash. I used plastic squares with a little "tab" in them and epoxied them up under the gunnels then wire tied the light strips to the tabs...shouldn't go anywhere

I wish I had some pixs of them lit...all these lit engine bays look awesome! Can't wait to get my boat back and turn on the lights

How many strips do you have in the bilge

Do you have a link to where you bought your lights?