OH MY GOD!!! Beautiful!:eekdrop:

Coming together great.

We made everything we need to dyno the engines just like they run in the boat!! We finished up all the brackets, hoses, tail pipes with 02 sensors etc etc late last night!

We were able to fire it up and seat the rings!! Should have some numbers today.


First Fire Off Video ( Click the link to view)
http://i1123.photobucket.com/albums/...psf4620514.jpg


On the Dyno - We have dyno valve covers on so the paint job didnt get messed up!!
http://i1123.photobucket.com/albums/...psdc73bf31.jpg




http://i1123.photobucket.com/albums/...psb5f99857.jpg




http://i1123.photobucket.com/albums/...psea81aa95.jpg




http://i1123.photobucket.com/albums/...ps242bf896.jpg

Looks great. If you can Dyno the motor with and without the flame arrestor. Would like to see the difference with the low flame arrestor. I have had this discussion with a few people before

Keep up the Great work

Mark

1 engine down 1 to go. Lets just say it made pretty good steam. Marks all smiles!!! I will test the flame arresters back to back for you tomorrow and post results. Thanks Joe Irwin

nice looking monsters!!!

Well we have some 925's in the boat now!!

First Engine made 926hp @ 6100 rpm!! That was a super safe tune up with 93 octane pump gas and 6lbs boost! Second engine is fired off with the 925 tune up loaded into it so we can check it tomorrow.... It was getting to late to run the engine tonight.



Click the picture to view the video
http://i1123.photobucket.com/albums/...ps169f4215.jpg



Click the picture to view the video
http://i1123.photobucket.com/albums/...psf26d964e.jpg




Joe Irwin from Fast Forward Race Engines in the Dyno Room!!
http://i1123.photobucket.com/albums/...pse5942314.jpg

Thank you!! Very happy with them!

Joe is going to run a back to back test tomorrow... From what I have seen so far they make the same power on or off..

Thank you!! Ready to get them in the boat!