This is hands down my favorite thread in this forum. Keep it up, can’t wait to see the finished product.

WOW, Just Wow! That is some dedication!

Gonna be so nice

Just going threw camera roll these pics were from when i removes the liner in the cabin looks like the liner was just sat in over top of some wiring. 25 years of abuse.

This is what made me decide to re wire entire boat. That is all the wiring that runs up the Stb side next to helm we’re it sits on top of the side bulk head (that was broke) all the wiring is rubbed threw. So that’s explains the gauges dancing around and lights flickering. If you have those problems check there !!!

That’s cabin tabbing that I was able to peal off in pieces that used to tab in the liner.

Always wondered what that smell was 😂

Those circuits probably did not work very well either. Someone was lucky there was not a fire !!

This is that piece of wood that they used as a half bulk head they glasses to the side with tabbing and then it runs behind the dash area and in my boat was never attached to anything so it was sandwiched between the liner and the dash. I had small spider crackes on the outside due to that hitting the side wall. If your dash area rattles check that area !!!

That’s when I decided to rip out every thing. All the wiring all the old bulk heads and start fresh amazing how these things get out of control lol

Yea no turning back now 😁
Sure will be nice once it’s finished.

What is amazing is how it looked when you started. It wasn’t like you were tearing into some rat of a boat!

mine has the same tabbing issue under the dash.