Just Turbines
03-01-2014, 01:45 PM
#421
Registered
Thread Starter
back
03-01-2014, 01:47 PM
#422
Registered
Thread Starter
03-01-2014, 01:49 PM
#423
Registered
Thread Starter
these small screws keep it together for now
use the lager ones torque to 165inch lbs then tighten screws then remove the
big 12 points.
now the screws are holding it
use the lager ones torque to 165inch lbs then tighten screws then remove the
big 12 points.
now the screws are holding it
03-01-2014, 01:50 PM
#424
Registered
Thread Starter
drop the deflector over it
03-01-2014, 01:52 PM
#425
Registered
Thread Starter
now get your 1st gp nozzle and drop it over that
i got a little ahead of myself in this shot i installed the pinch plate and the forward seal without the seal runner
i removed it and dropped it on there then reinstalled the forward seal
i got a little ahead of myself in this shot i installed the pinch plate and the forward seal without the seal runner
i removed it and dropped it on there then reinstalled the forward seal
Last edited by KNOT-RIGHT; 03-01-2014 at 01:54 PM.
03-01-2014, 01:57 PM
#426
Registered
Thread Starter
this is how it should look
03-01-2014, 01:59 PM
#427
Registered
Thread Starter
the six bolts are shown here also torque to 165 inch lbs.
the 703 version does not use the stud and nut version that i showed earlier in this thread.
(the one that was snapped off)
the 703 version does not use the stud and nut version that i showed earlier in this thread.
(the one that was snapped off)
03-01-2014, 02:04 PM
#428
Registered
Thread Starter
here is the sealing flange louvered that is also a 703 part.
the bolts are torqued to 105 inch lbs.
and safety wired
the bolts are torqued to 105 inch lbs.
and safety wired
03-01-2014, 04:29 PM
#429
Gold Member
Gold Member
Those would have solved some of my potato shooter issues I had as a kid!!!!!!
03-01-2014, 08:01 PM
#430
Registered
Thread Starter
