back

these small screws keep it together for now
use the lager ones torque to 165inch lbs then tighten screws then remove the
big 12 points.
now the screws are holding it

drop the deflector over it

now get your 1st gp nozzle and drop it over that
i got a little ahead of myself in this shot i installed the pinch plate and the forward seal without the seal runner
i removed it and dropped it on there then reinstalled the forward seal

this is how it should look

the six bolts are shown here also torque to 165 inch lbs.
the 703 version does not use the stud and nut version that i showed earlier in this thread.
(the one that was snapped off)

here is the sealing flange louvered that is also a 703 part.
the bolts are torqued to 105 inch lbs.
and safety wired

Those would have solved some of my potato shooter issues I had as a kid!!!!!!

and dont forget the oxy acetlyn filled garbage bags.