carney

Candyman, You must be saying that fountain raised the motor first ,then used the top hole in the stellings box. Yes mine are stellings. But if I put mine in the top hole that will put the drive lower in the water. It will lower the ext box. The bolts are in the bottom hole now and I can not trim the drive with out them hitting the swimplatform. and with the drives against the platform at 5200 there is no rooster at all. I think this is slowing the boat .??????????????

carney

I checked the drive height tonight, they are 4inches from the bottom of the boat to the center of the prop shaft. Does anyone know what this should be with boxes?

Ran-Dom 32

I will be posting before & after results on my 35 going from stock bravo drive to -2 sportmaster lowers - going to run same props (28b1s) & borrow a set of 30's - hopefully pick up some MPH

carney

That would be great. What power do you have.

Ran-Dom 32

500hp's w/upgrades

carney

If we get the rain that is due , you will not be able to test. I hope they work out for you.

Ran-Dom 32

they are bolted on & ready to go - just waiting for the weather to co-operate

10x

On a SSM IV or V, my prop shafts are 1" below the bottom of the hull. That's with Merc 12" boxes.

mv35

hi guys iv'e had my 2" shortys on my 97 single step for 3 years,i picked up 5 mph just bolt on.so far 104 mph is my best speed.im going to remove the defusor ring from my maximus 5 blades this weekend.

carney

Did Chris M. do the drives for you? what power do you have to get 104.