Fountain 33' Executioner
#12
Registered
iTrader: (3)
Join Date: Dec 2003
Location: Cleveland, OH / Pewaukee, WI
Posts: 5,870
Received 365 Likes
on
209 Posts
I'm new to Fountain power boats, and just purchased a 1983 33' Executioner, less motors. My question is the rotation of the motors, (it came with one left rotation prop?). Also missing are one bellhousing, wiring harness, and rear engine mount plates! The current bellhousing looks like it has water connectors?, this is something new to me. Also are wire schematics available? What motors were stock, and what kind of ignition? Any help would be appreciated. Thanks Harry
#15
Registered
iTrader: (3)
Join Date: Dec 2003
Location: Cleveland, OH / Pewaukee, WI
Posts: 5,870
Received 365 Likes
on
209 Posts
I know the owner who you bought it from. It was a fast boat. Did it come with out drives? There shouldnt be to much work involved to get it running. If your going to do a full restore then it will take some time. Are you also from the great state of ohio?
Jr.
Jr.
#18
Platinum Member
Platinum Member
Thread Starter
Join Date: Aug 2007
Location: New Carlisle, IN
Posts: 146
Likes: 0
Received 0 Likes
on
0 Posts
My wife and I picked up the boat this weekend. After getting a close at the cockpit carpet, I noticed it is glued in, but my wife cleaned it like new yesterday. Yes we are from New Carlisle, IN. This looks like it will be a great winter project. Talked to Bob Teague at Teague Performance Marine today and got a good start on locating some missing motor parts. This boat just needed a littile TLC and a good cleaning, hard to believe its 25 yrs old. Does anyone have a mercriuser bellhousing with trans and motor oil cooler? (just need bellhousing)
Thread
Thread Starter
Forum
Replies
Last Post
nordy racer
General Boating Discussion
8
08-22-2006 11:36 AM