![]() |
Originally Posted by triple 300s
(Post 3686214)
Same....FPM was doing high speed runs...popped the hatch for some ram-air induction. Boat was going so fast it ripped off hatch, boat went back to shop to pick up scuba divers, hatch recovered. Owner wants more speed...Rear bench seating being removed for a full stagger set up...should run 125mph (very unstablish), but faster than you....lol:lolhit:
|
Originally Posted by TRL505
(Post 3685616)
Kwright.....whats the latest???
|
Originally Posted by KWright
(Post 3686858)
Busy weekend at home, Reggie is going to run it again this week I'm going to pick it up on friday. It is a bit over proped. this works out good for me, cause I have a couple things left to do with the motors. I'm going to end up being down 5-600 rpm. so it should be fine. the speed when it leaves FPM sould be 94 mph. so it will leave me some room for improvement after we finish the motors.
|
Originally Posted by KWright
(Post 3679533)
New windsheild done!
|
Originally Posted by TRL505
(Post 3686917)
What engine mods? 500-600 is a quite a bit.
|
Originally Posted by Spinletto
(Post 3686989)
That windshield looks great!!! How much did they charge you for that? Parts and install.
|
Just got home from getting my boat back. Ended up with gaining 5 mph. Old set up was p5x hydros 29 pitch on xrs 5500 rpm 88 mph, new set up 30 pitch herings scx-4 5300 rpm 93 mph. Both these were made full of fuel and gear 3 people on board. I am currently over pitched but that is fine because this winter a few upgrades to motors will put me at my target rpm. Boat gets up on plane easy and runs straight and true. spent yesterday am on the water with Reggie and Rlll. Driving lesson from Sr. was great he sure has alot of little tricks.
|
3 Attachment(s)
|
Those drives look awesome. Glad to hear that you had such a positive experience.
|
Originally Posted by KWright
(Post 3693554)
|
| All times are GMT -5. The time now is 02:24 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.