Engine Rebuild/ New to OSO
#1
Gold Member
Gold Member
Thread Starter
Join Date: Apr 2008
Location: Destin, Fl
Posts: 148
Likes: 0
Received 0 Likes
on
0 Posts
Engine Rebuild/ New to OSO
Hey there everybody. I've been reading the post and checking everything everybody seems to be pretty cool.
Well I finally got me a boat - a 98 353 fastech w/twin 502 mags. the other day I was out and the starboard motor failed. Oil and water all over the engine hatch. Got the motors pulled and the starboard motor striped down to the block. Looks like the the intake failed at rear where it blocks the rear water port on the head. The intake rotted away right there and dumped water in to the valley. Is this a common problem?? Any remedies to keep this from happening again? Rest of the engine looks good the motors where quicksilver repowers the tags say 04. the water jacket are pretty clean no scaling, didnt bend any rods. So i think i can get away with honing, rings and bearings. Does any have or know where i can get lower intake? Best place to get a rebuild kit? Any thing else i should do while there out?
This is my first personal boat and it was the first time out takeing the fiancee out (she was thrilled about the motor after we just spend the money to buy the boat) But i dont think anyone could have known it was going to happen. Bad luck i guess.
I appreciate any help.
David
Well I finally got me a boat - a 98 353 fastech w/twin 502 mags. the other day I was out and the starboard motor failed. Oil and water all over the engine hatch. Got the motors pulled and the starboard motor striped down to the block. Looks like the the intake failed at rear where it blocks the rear water port on the head. The intake rotted away right there and dumped water in to the valley. Is this a common problem?? Any remedies to keep this from happening again? Rest of the engine looks good the motors where quicksilver repowers the tags say 04. the water jacket are pretty clean no scaling, didnt bend any rods. So i think i can get away with honing, rings and bearings. Does any have or know where i can get lower intake? Best place to get a rebuild kit? Any thing else i should do while there out?
This is my first personal boat and it was the first time out takeing the fiancee out (she was thrilled about the motor after we just spend the money to buy the boat) But i dont think anyone could have known it was going to happen. Bad luck i guess.
I appreciate any help.
David
#2
Gold Member
Gold Member
Thread Starter
Join Date: Apr 2008
Location: Destin, Fl
Posts: 148
Likes: 0
Received 0 Likes
on
0 Posts
Yes its a saltwater boat. I am, Well my mechanic is doing the work. Were going to tear down the other as well. That way I atleast know what i got.
How much is rebuild kit?
Thanks,
David
How much is rebuild kit?
Thanks,
David
#5
Gold Member
Gold Member
Thread Starter
Join Date: Apr 2008
Location: Destin, Fl
Posts: 148
Likes: 0
Received 0 Likes
on
0 Posts
Thats good know. I'll check but if it is i doubt it would be covered. Because the intake failed and not anything with the rebuilt motor.
Thanks for the help,
David
Thanks for the help,
David
#6
Registered
Join Date: Dec 2000
Location: Bell Canyon, CA
Posts: 12,754
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
gotime34
General Boating Discussion
46
07-10-2005 08:20 PM