![]() |
Originally Posted by ReggieRaft
(Post 3389022)
Have a slip at drumpoint marina,but will use proroc for in and out service. I have used my jet skis to explore and i know forked river and tices. Plus do the njppc events.
|
Great . pull up and say hello,lets hang out and cruse somewhere fun. greig.
|
Originally Posted by ita1iansta11ion1
(Post 3388711)
y? dont think it will go 90? it was a 75 mph boat with a little under 500hp. another 200hp wont get it there?
I have a new prop to try this year. 29" labbed Cutting Edge prop. This prop has a little more diameter to cut down on slippage. Can't wait to try it out. |
Originally Posted by F1-00 Racing
(Post 3389546)
Per APBA measurements a 29 Fountain has a running surface of 26' 10".
Good luck Stallion!! More importantly be safe and yes a set of 380's mounted level will only help you. My 29 with a stock sealed 500EFI will do 92.7 so you should be able to have a lot of fun. |
Originally Posted by Eliminator28
(Post 3389947)
:bsflag: Aren't the 29's twin's?
|
|
Originally Posted by Crossett
(Post 3388802)
Wow, that's it? What about the 29?
|
Originally Posted by Eliminator28
(Post 3389947)
:bsflag: Aren't the 29's twin's?
|
I'd be willing to bet that JimV has spent countless hours getting to the speeds he achieves...and numerous set-up changes...so much more to it than just an extra 100 horsepower give or take:coolcowboy:
I'm not throwing water on your campfire, just pointing out the boat your comparing yours to is not just another boat with more hp...much more to the story |
I don't disagree at all with all the warnings given so far, but what the OP is aiming at is indeed feasible.
And yes, with a NA engine, a non stepped 27 Fever, and a Bravo drive. [youtube]e_8c5tyH9VE[/youtube] PS: ooops, sorry, I posted this before seeing that the thread had more than one page, and didn't realise it has already been posted... |
Originally Posted by Too Stroked
(Post 3389650)
I agree that no boat has a running surface equal to its length - no matter how you measure it. However, no manufacturer measures "wetted running surface at top speed" either. If that were the case, my 22' Progression would be about 2' long - because that's all that's in the water at speed.
Many boats are however much shorter than a classic flat transom (no molded in platform) hull measured the old way. The Fountain "beak" is one commonly complained about example - but it's at the bow. Molded in swim platforms - except for certain Four Winns models - add nothing to the running surface at the stern - where it matters most. |
1 Attachment(s)
Originally Posted by ita1iansta11ion1
(Post 3388436)
Whats up OSO, I picked up a clean 27' Fountain single, no step bottom, in the fall of last year. I am currently having a fresh custom 510ci N.A. motor being built at Bandit Performance Marine (Formerly Kurt's Marine) on Mantoloking Rd. in Brick, NJ. I cant say enough times how helpful, friendly and informative they have been. Not sure of the H.P. until im on the dyno but im crossing my fingers for 90MPH. Looking for a quick race just for fun or a small wager. I will accept fair twin engine competition also. Im usually blasting around the bay in between the Seaside and Mantoloking bridges. Thanks guys, The Instagator.
|
Originally Posted by berns29scarab
(Post 3390265)
welcome...whats your name and where abouts are ya from ? i've also got a single engine 27 (kryptonite) with a stock 500 efi which runs a touch over 80. i will be using her as a bay bomber and hopefully racing class 5 with the OPA as well.
I thought P5 was 75 and under :lolhit::lolhit: |
Originally Posted by Ted G
(Post 3390292)
I thought P5 was 75 and under :lolhit::lolhit:
|
Originally Posted by Eliminator28
(Post 3389947)
:bsflag: Aren't the 29's twin's?
By all means it is not a normal 29 Fever. It is a F1 race version. Yes some pleasures did come with twins, but I am pretty sure more singles in recent years were produced. |
TED, the "P" was dropped years ago, its Class 5 now:drink:.
|
Damn, lucky I'm not in charge of the race anymore, I don't know WTF I'm talking about :lolhit::lolhit:
|
Ted, I hear Ocean City could use a new race director/Promoter??? You did a great job with Cambridge!!
|
Originally Posted by Fast Shafts
(Post 3390385)
Ted, I hear Ocean City could use a new race director/Promoter??? You did a great job with Cambridge!!
|
Originally Posted by F1-00 Racing
(Post 3390343)
ummmm no. Mine is and always has been a single.
By all means it is not a normal 29 Fever. It is a F1 race version. Yes some pleasures did come with twins, but I am pretty sure more singles in recent years were produced. The 27' Fountain that this thread is about is a straight V. |
Originally Posted by F1-00 Racing
(Post 3390343)
ummmm no. Mine is and always has been a single.
By all means it is not a normal 29 Fever. It is a F1 race version. Yes some pleasures did come with twins, but I am pretty sure more singles in recent years were produced. The F1 race version? I guess would explain the "above normal speed" for a boat with that power. What is different? Weight I would imagine for one thing.. |
There was a 32' single sunsation running in the low 90's with a ton of HP.
|
Its another Pit Bull lol
|
Originally Posted by Eliminator28
(Post 3390406)
I was not aware they came with singles. I looked at one before I bought my current Boat and it had twins. I assumed they all were built that way. That's what I get for assuming..
The F1 race version? I guess would explain the "above normal speed" for a boat with that power. What is different? Weight I would imagine for one thing.. pics of it are at www.tntoffshore.com in the multimedia section 2009 and prior |
Do i have to choke a ***** out???:coolcowboy::evilb::drink:
|
I thought someone had an old 90s skater with a KE engine and a single 6 drive around there.......the boat was a yellow cat.
|
Thanks
Originally Posted by ita1iansta11ion1
(Post 3388436)
Whats up OSO, I picked up a clean 27' Fountain single, no step bottom, in the fall of last year. I am currently having a fresh custom 510ci N.A. motor being built at Bandit Performance Marine (Formerly Kurt's Marine) on Mantoloking Rd. in Brick, NJ. I cant say enough times how helpful, friendly and informative they have been. Not sure of the H.P. until im on the dyno but im crossing my fingers for 90MPH. Looking for a quick race just for fun or a small wager. I will accept fair twin engine competition also. Im usually blasting around the bay in between the Seaside and Mantoloking bridges. Thanks guys, The Instagator.
|
I know the 27 fever and I am on the Barnaget Bay and it is a hand full to drive over 70 on a weekend with all the boat traffic!!!! My 10 meter does 78 and I destory my buddies 27 fever that runs the same speed cause he can't hang on to it on the weekends..Only in the am or late afternoons he can do the speeds..Look out for berns29 scarab with his 27 kyrptonite he will give you a beatin!!!!LOL.Lookout for my old boat I sold it to a guy and it is rite behind East Dover marina. It is a all white 27 excalibur and it has the name in blue Pandemonium on the side. He will give you a run for the money... When I ran it it ran 86 all day long.... Have fun this summer with it.....
|
Lookout for my old boat I sold it to a guy and it is rite behind East Dover marina. It is a all white 27 excalibur and it has the name in blue Pandemonium on the side. He will give you a run for the money... When I ran it it ran 86 all day long.
i had a run in with pandemoneum last september and a quick blast towards the seaside bridge and i was out in front. thats when i was 500hp. hope to see that boat this summer b/c i am in the area. update on motor, just dyno'd, 510ci, single 4-bbl, n.a., 9.8:1, 700hp@6300, 650tq@5200. thanks to bandit performance marine. |
low 80 mph boat
|
bring your wallet
Originally Posted by ita1iansta11ion1
(Post 3399377)
Lookout for my old boat I sold it to a guy and it is rite behind East Dover marina. It is a all white 27 excalibur and it has the name in blue Pandemonium on the side. He will give you a run for the money... When I ran it it ran 86 all day long.
i had a run in with pandemoneum last september and a quick blast towards the seaside bridge and i was out in front. thats when i was 500hp. hope to see that boat this summer b/c i am in the area. update on motor, just dyno'd, 510ci, single 4-bbl, n.a., 9.8:1, 700hp@6300, 650tq@5200. thanks to bandit performance marine. |
Originally Posted by ReggieRaft
(Post 3389859)
Great . pull up and say hello,lets hang out and cruse somewhere fun. greig.
|
Dude this has got to be your first speed boat...Your already saying how fast your going to be. Okay your Motor dynoed 700hp get it in the boat and see what it runs. Every buddy says there boat runs faster than it does..It takes time to dial it in with the right prop. I bet money that the 502 you had in it with the aluminum heads and the single plane intake with an 850 and headers made more than 500hp more like 550 or more. so get it in and see what it runs......Just sayin
|
I feel like trailering my Baja up there this summer, sounds fun and competitive.
|
All I got to say is come summer time its game over for all you single engine boats and even some twin engine boats (robert) in the barnegat bay! :party-smiley-004:
|
pandemonium
ding ding..........let the games begin
|
Erik I can't wait for you..I want my prop back lol....
|
Originally Posted by excalibur82
(Post 3399812)
Dude this has got to be your first speed boat...Your already saying how fast your going to be. Okay your Motor dynoed 700hp get it in the boat and see what it runs. Every buddy says there boat runs faster than it does..It takes time to dial it in with the right prop. I bet money that the 502 you had in it with the aluminum heads and the single plane intake with an 850 and headers made more than 500hp more like 550 or more. so get it in and see what it runs......Just sayin
|
Originally Posted by excalibur82
(Post 3399812)
Dude this has got to be your first speed boat...Your already saying how fast your going to be. Okay your Motor dynoed 700hp get it in the boat and see what it runs. Every buddy says there boat runs faster than it does..It takes time to dial it in with the right prop. I bet money that the 502 you had in it with the aluminum heads and the single plane intake with an 850 and headers made more than 500hp more like 550 or more. so get it in and see what it runs......Just sayin
|
Originally Posted by scarabman
(Post 3400182)
Didnt he say earlier he was just talking smack trying to get a little fun rivalry going? Seeing as how I am right in that area, I have found this thread to be mildly entertaining and interesting to to see who chirps in.
|
| All times are GMT -5. The time now is 01:23 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.